About Broomfield Fire and EMS Frequencies
Quick answer: County-level fire dispatch that covers Broomfield: North Metro Fire/Rescue 460.5500 MHz, narrow FM, 151.4 PL.
- 1 conventional channel is analog FM, so any scanner can receive it. Enter the frequency and set the tone shown in the table.
Data updated .
Broomfield County channels that also cover Broomfield
Fire Dispatch
| Agency | Description | Frequency (MHz) | Tone | Mode | FCC |
|---|---|---|---|---|---|
| North Metro Fire/Rescue | North Metro Fire – Broomfield County Paging Tones | 460.5500 In 465.5500 | 151.4 PL | FMN | WPDV509 |
Nearest trunked radio sites
Distances are measured from the center of Broomfield.
What do these numbers mean?
- Control channel
- The frequency your scanner listens to first. It tells the scanner where each voice call is happening, so program it before anything else.
- Voice
- The other frequencies the site uses for calls. A trunking scanner follows them automatically once it has the control channel.
- Site
- One tower location of the system. Scanners show the number in decimal or hex, so both are listed.
- RFSS (Radio Frequency Sub-System)
- A group of sites run by the same controller. Large Project 25 systems can have several.
- NAC (Network Access Code)
- A hex code the site transmits. Your scanner can use it to ignore other systems on the same frequency.
- Talkgroup
- A virtual channel on a trunked system, such as one agency’s dispatch. Programming uses the decimal or hex number, depending on your scanner.
Common questions
What frequency does the fire department use in Broomfield?
We do not have a fire dispatch channel listed specifically for Broomfield. The county-level fire dispatch channels in the same county: North Metro Fire/Rescue 460.5500 MHz, narrow FM, 151.4 PL.
What scanner do I need to listen to fire and EMS in Broomfield?
The analog conventional channels can be heard on any scanner.
What are the control channels for trunked radio in Broomfield?
For Broomfield, start with the Westminster Simulcast site of Front Range Communications Consortium (FRCC). Its control channels are 851.0625, 852.8875 MHz. Program a control channel first; the scanner finds the voice channels from it.