Skip to content

Washington Fire and EMS Frequencies

We do not have frequencies listed specifically for Washington in Wayne County, Indiana yet. Countywide channels for Wayne County that may also cover this area are shown below when we have them. The closest trunked radio site we have is Centerville (Indiana Project Hoosier SAFE-T), about 6 miles away.

About Washington Fire and EMS Frequencies

Quick answer: County-level fire dispatch that covers Washington: Wayne County Fire 154.0100 MHz, narrow FM, 151.4 PL (backup). County-level ems dispatch that covers Washington: Culberson Ambulance Service 155.2350 MHz, narrow FM, 114.8 PL; Indiana University Health Life Line 153.1850 MHz, narrow FM, 173.8 PL. Trunked: Indiana Project Hoosier SAFE-T, for example Wayne County Fire talkgroup 11024 (hex 2b10).

  • 7 conventional channels are analog FM, so any scanner can receive them. Enter the frequency and set the tone shown in the table.
  • Trunked radio systems that carry fire and EMS traffic here: Indiana Project Hoosier SAFE-T: 4 talkgroups. A trunking scanner is required, and it must support the system type shown.
  • To follow a trunked system, program a control channel first. For Washington, start with the Centerville site of Indiana Project Hoosier SAFE-T, about 6 miles away. Its control channels: 771.86875, 772.49375, 772.74375 MHz.

Data updated .

Wayne County channels that also cover Washington

Fire Dispatch

Fire Dispatch frequencies for Wayne County
AgencyDescriptionFrequency (MHz)ToneModeFCC
Wayne County Fire BackupWayne County Fire – Dispatch154.0100151.4 PLFMNWPCB426

Fire Ground / Tactical

Fire Ground / Tactical frequencies for Wayne County
AgencyDescriptionFrequency (MHz)ToneModeFCC
Wayne County FireWayne County Fire – Tactical Channel154.2350FMN—
Wayne County FireWayne County Fire – Tactical Channel154.2650CSQFMNWPCB426
Wayne County FireWayne County Fire – Tactical Channel154.2800FMN—
Wayne County FireWayne County Fire – Tactical Channel154.2950CSQFMNWPCB426

EMS Dispatch

EMS Dispatch frequencies for Wayne County
AgencyDescriptionFrequency (MHz)ToneModeFCC
Culberson Ambulance ServiceCulberson Ambulance Service – Dispatch155.2350
In 153.6200
114.8 PLFMNKNAZ321
Indiana University Health Life LineIndiana University Health Life Line – Dispatch153.1850173.8 PLFMNWQVB765

Indiana Project Hoosier SAFE-T

Indiana Project Hoosier SAFE-T talkgroups
AgencyDescriptionTalkgroupHexMode
Wayne County FireCounty Fire/Reid EMS – Paging (only)110242b10D
Wayne County FireCounty Fire/Reid EMS – Dispatch124373095D
Wayne County FireWayne County Fire – Fire Ground (County)124383096D
Wayne County FireWayne County Fire – Fire Ground (County)124393097D

Nearest trunked radio sites

Distances are measured from the center of Washington.

Centerville · Indiana Project Hoosier SAFE-T
RFSS 1 · Site 60 (hex 3C) · NAC 6BA · about 6 mi away
Control 771.86875, 772.49375, 772.74375, 774.21875
Voice 771.09375
Connersville · Indiana Project Hoosier SAFE-T
RFSS 1 · Site 38 (hex 26) · NAC 6B8 · about 9 mi away
Control 851.8875, 852.3875, 853.725
Voice 851.2, 851.45
Richmond · Indiana Project Hoosier SAFE-T
RFSS 1 · Site 71 (hex 47) · NAC 6B1 · about 12 mi away
Control 852.9375, 853.1125
Voice 851.2875, 851.55, 852.25
What do these numbers mean?
Control channel
The frequency your scanner listens to first. It tells the scanner where each voice call is happening, so program it before anything else.
Voice
The other frequencies the site uses for calls. A trunking scanner follows them automatically once it has the control channel.
Site
One tower location of the system. Scanners show the number in decimal or hex, so both are listed.
RFSS (Radio Frequency Sub-System)
A group of sites run by the same controller. Large Project 25 systems can have several.
NAC (Network Access Code)
A hex code the site transmits. Your scanner can use it to ignore other systems on the same frequency.
Talkgroup
A virtual channel on a trunked system, such as one agency’s dispatch. Programming uses the decimal or hex number, depending on your scanner.

Common questions

What frequency does the fire department use in Washington?

We do not have a fire dispatch channel listed specifically for Washington. The county-level fire dispatch channels in the same county: Wayne County Fire 154.0100 MHz, narrow FM, 151.4 PL (backup).

What frequency does EMS or the ambulance service use in Washington?

We do not have a EMS dispatch channel listed specifically for Washington. The county-level EMS dispatch channels in the same county: Culberson Ambulance Service 155.2350 MHz, narrow FM, 114.8 PL; Indiana University Health Life Line 153.1850 MHz, narrow FM, 173.8 PL.

Do fire departments and EMS use a trunked radio system in Washington?

Yes. The county-level systems that cover Washington are Fire and EMS talkgroups are listed for Indiana Project Hoosier SAFE-T: 4 talkgroups. A trunking scanner is required.

What scanner do I need to listen to fire and EMS in Washington?

The analog conventional channels can be heard on any scanner; a trunking scanner is needed for the trunked talkgroups.

What are the control channels for trunked radio in Washington?

For Washington, start with the Centerville site of Indiana Project Hoosier SAFE-T. Its control channels are 771.86875, 772.49375, 772.74375, 774.21875 MHz. Program a control channel first; the scanner finds the voice channels from it.