Skip to content

Portland Fire and EMS Frequencies

We do not have frequencies listed specifically for Portland in Cerro Gordo County, Iowa yet. Countywide channels for Cerro Gordo County that may also cover this area are shown below when we have them. The closest trunked radio site we have is Mason City (Iowa Statewide Interoperable Communications System (ISICS)), about 3 miles away.

About Portland Fire and EMS Frequencies

Quick answer: County-level fire dispatch that covers Portland: Cerro Gordo County Fire 154.2350 MHz, narrow FM, CSQ. Trunked: Iowa Statewide Interoperable Communications System (ISICS), for example Cerro Gordo Mason City Fire talkgroup 21629 (hex 547d).

  • 1 conventional channel is analog FM, so any scanner can receive it. Enter the frequency and set the tone shown in the table.
  • Trunked radio systems that carry fire and EMS traffic here: Iowa Statewide Interoperable Communications System (ISICS): 5 talkgroups. A trunking scanner is required, and it must support the system type shown.
  • To follow a trunked system, program a control channel first. For Portland, start with the Mason City site of Iowa Statewide Interoperable Communications System (ISICS), about 3 miles away. Its control channels: 769.90625, 770.15625, 770.40625 MHz.
  • 1 listed entry is marked encrypted. No scanner can decode encrypted audio.

Data updated .

Cerro Gordo County channels that also cover Portland

Fire Dispatch

Fire Dispatch frequencies for Cerro Gordo County
AgencyDescriptionFrequency (MHz)ToneModeFCC
Cerro Gordo County FireCerro Gordo County Fire – Dispatch154.2350CSQFMNKRM652

Iowa Statewide Interoperable Communications System (ISICS)

Iowa Statewide Interoperable Communications System (ISICS) talkgroups
AgencyDescriptionTalkgroupHexMode
Cerro Gordo Mason City FireCerro Gordo Mason City Fire – Dispatch21629547dT
Cerro Gordo Mason City FireFire Info21630547eT
Cerro Gordo Mason City FireCerro Gordo Mason City Fire – Tactical Channel21631547fT
Cerro Gordo Mason City FireCerro Gordo Mason City Fire – Tactical Channel216325480T
1 encrypted talkgroup (cannot be monitored)
Iowa Statewide Interoperable Communications System (ISICS) encrypted talkgroups
AgencyDescriptionTalkgroupHexMode
Cerro Gordo County HospitalEMS-to-Hospital Patient Reports216355483T Encrypted

Nearest trunked radio sites

Distances are measured from the center of Portland.

Mason City · Iowa Statewide Interoperable Communications System (ISICS)
RFSS 1 · Site 65 (hex 41) · NAC 4C4 · about 3 mi away
Control 769.90625, 770.15625, 770.40625
Voice 769.65625
Floyd Co Simulcast · Iowa Statewide Interoperable Communications System (ISICS)
RFSS 2 · Site 34 (hex 22) · about 18 mi away
Control 774.33125
Voice 773.58125, 773.83125
Joice · Iowa Statewide Interoperable Communications System (ISICS)
RFSS 2 · Site 98 (hex 62) · NAC 4C2 · about 22 mi away
Control 770.94375, 774.56875, 774.81875
Voice 770.69375
What do these numbers mean?
Control channel
The frequency your scanner listens to first. It tells the scanner where each voice call is happening, so program it before anything else.
Voice
The other frequencies the site uses for calls. A trunking scanner follows them automatically once it has the control channel.
Site
One tower location of the system. Scanners show the number in decimal or hex, so both are listed.
RFSS (Radio Frequency Sub-System)
A group of sites run by the same controller. Large Project 25 systems can have several.
NAC (Network Access Code)
A hex code the site transmits. Your scanner can use it to ignore other systems on the same frequency.
Talkgroup
A virtual channel on a trunked system, such as one agency’s dispatch. Programming uses the decimal or hex number, depending on your scanner.

Common questions

What frequency does the fire department use in Portland?

We do not have a fire dispatch channel listed specifically for Portland. The county-level fire dispatch channels in the same county: Cerro Gordo County Fire 154.2350 MHz, narrow FM, CSQ.

Do fire departments and EMS use a trunked radio system in Portland?

Yes. The county-level systems that cover Portland are Fire and EMS talkgroups are listed for Iowa Statewide Interoperable Communications System (ISICS): 5 talkgroups. A trunking scanner is required.

What scanner do I need to listen to fire and EMS in Portland?

The analog conventional channels can be heard on any scanner; a trunking scanner is needed for the trunked talkgroups.

What are the control channels for trunked radio in Portland?

For Portland, start with the Mason City site of Iowa Statewide Interoperable Communications System (ISICS). Its control channels are 769.90625, 770.15625, 770.40625 MHz. Program a control channel first; the scanner finds the voice channels from it.