Skip to content

Washington Fire and EMS Frequencies

We do not have frequencies listed specifically for Washington in Wabaunsee County, Kansas yet. Countywide channels for Wabaunsee County that may also cover this area are shown below when we have them. The closest trunked radio site we have is Dwight (Kansas Statewide Interoperable Communication System (KSICS)), about 12 miles away.

About Washington Fire and EMS Frequencies

Quick answer: County-level fire dispatch that covers Washington: Wabaunsee County Fire 154.0850 MHz, narrow FM, 156.7 PL. Trunked: Kansas Statewide Interoperable Communication System (KSICS), for example Wabaunsee County Fire talkgroup 1321 (hex 529).

  • 8 conventional channels are analog FM, so any scanner can receive them. Enter the frequency and set the tone shown in the table.
  • Trunked radio systems that carry fire and EMS traffic here: Kansas Statewide Interoperable Communication System (KSICS): 1 talkgroup. A trunking scanner is required, and it must support the system type shown.
  • To follow a trunked system, program a control channel first. For Washington, start with the Dwight site of Kansas Statewide Interoperable Communication System (KSICS), about 12 miles away. Its control channels: 851.55, 852.3375 MHz.

Data updated .

Wabaunsee County channels that also cover Washington

Fire Dispatch

Fire Dispatch frequencies for Wabaunsee County
AgencyDescriptionFrequency (MHz)ToneModeFCC
Wabaunsee County FireCounty Fire – Maple Hill Repeater154.0850
In 158.8950
156.7 PLFMNWNXS965
Wabaunsee County FireCounty Fire – Eskridge Repeater154.7550
In 159.2400
79.7 PLFMNWQBN878
Wabaunsee County FireCounty Fire – Alma Repeater155.0700
In 158.8500
179.9 PLFMNWQBN878
Wabaunsee County FireCounty Fire – Alta Vista Repeater155.3400
In 159.2250
167.9 PLFMNWQBN878

Fire Ground / Tactical

Fire Ground / Tactical frequencies for Wabaunsee County
AgencyDescriptionFrequency (MHz)ToneModeFCC
Wabaunsee County FireCounty Fire Tactical154.7700156.7 PLFMN—
Wabaunsee County FireCounty Fire Tactical155.4300136.5 PLFMN—
Wabaunsee County FireCounty Fire Tactical155.9100167.9 PLFMN—
Wabaunsee County FireCounty Fire Tactical156.0900179.9 PLFMN—

Kansas Statewide Interoperable Communication System (KSICS)

Kansas Statewide Interoperable Communication System (KSICS) talkgroups
AgencyDescriptionTalkgroupHexMode
Wabaunsee County FireCounty Fire Interoperations1321529D

Nearest trunked radio sites

Distances are measured from the center of Washington.

Dwight · Kansas Statewide Interoperable Communication System (KSICS)
RFSS 2 · Site 13 (hex D) · NAC 1B2 · about 12 mi away
Control 851.55, 852.3375
Voice 851.275, 853.175, 853.35, 853.6125
Manhattan · Riley County
RFSS 35 · Site 35 (hex 23) · NAC 023 · about 14 mi away
Control 851.2, 851.6625, 852.1375, 852.6375
Wamego · Kansas Statewide Interoperable Communication System (KSICS)
RFSS 2 · Site 53 (hex 35) · NAC 1B2 · about 16 mi away
Control 856.9875, 857.2375
Voice 856.4375, 856.4875, 858.4625, 859.2375, 859.7625
What do these numbers mean?
Control channel
The frequency your scanner listens to first. It tells the scanner where each voice call is happening, so program it before anything else.
Voice
The other frequencies the site uses for calls. A trunking scanner follows them automatically once it has the control channel.
Site
One tower location of the system. Scanners show the number in decimal or hex, so both are listed.
RFSS (Radio Frequency Sub-System)
A group of sites run by the same controller. Large Project 25 systems can have several.
NAC (Network Access Code)
A hex code the site transmits. Your scanner can use it to ignore other systems on the same frequency.
Talkgroup
A virtual channel on a trunked system, such as one agency’s dispatch. Programming uses the decimal or hex number, depending on your scanner.

Common questions

What frequency does the fire department use in Washington?

We do not have a fire dispatch channel listed specifically for Washington. The county-level fire dispatch channels in the same county: Wabaunsee County Fire 154.0850 MHz, narrow FM, 156.7 PL.

Do fire departments and EMS use a trunked radio system in Washington?

Yes. The county-level systems that cover Washington are Fire and EMS talkgroups are listed for Kansas Statewide Interoperable Communication System (KSICS): 1 talkgroup. A trunking scanner is required.

What scanner do I need to listen to fire and EMS in Washington?

The analog conventional channels can be heard on any scanner; a trunking scanner is needed for the trunked talkgroups.

What are the control channels for trunked radio in Washington?

For Washington, start with the Dwight site of Kansas Statewide Interoperable Communication System (KSICS). Its control channels are 851.55, 852.3375 MHz. Program a control channel first; the scanner finds the voice channels from it.