About Judith Gap Fire and EMS Frequencies
Quick answer: County-level ems dispatch that covers Judith Gap: Wheatland County EMS 154.9650 MHz, narrow FM, no tone.
- 1 conventional channel is analog FM, so any scanner can receive it. Enter the frequency and set the tone shown in the table.
Data updated .
Wheatland County channels that also cover Judith Gap
EMS Dispatch
| Agency | Description | Frequency (MHz) | Tone | Mode | FCC |
|---|---|---|---|---|---|
| Wheatland County EMS | EMS Paging | 154.9650 | FMN | WPTY934 |
Nearest trunked radio sites
Distances are measured from the center of Judith Gap.
What do these numbers mean?
- Control channel
- The frequency your scanner listens to first. It tells the scanner where each voice call is happening, so program it before anything else.
- Voice
- The other frequencies the site uses for calls. A trunking scanner follows them automatically once it has the control channel.
- Site
- One tower location of the system. Scanners show the number in decimal or hex, so both are listed.
- RFSS (Radio Frequency Sub-System)
- A group of sites run by the same controller. Large Project 25 systems can have several.
- NAC (Network Access Code)
- A hex code the site transmits. Your scanner can use it to ignore other systems on the same frequency.
- Talkgroup
- A virtual channel on a trunked system, such as one agency’s dispatch. Programming uses the decimal or hex number, depending on your scanner.
Common questions
What frequency does EMS or the ambulance service use in Judith Gap?
We do not have a EMS dispatch channel listed specifically for Judith Gap. The county-level EMS dispatch channels in the same county: Wheatland County EMS 154.9650 MHz, narrow FM, no tone.
What scanner do I need to listen to fire and EMS in Judith Gap?
The analog conventional channels can be heard on any scanner.
What are the control channels for trunked radio in Judith Gap?
For Judith Gap, start with the Lewistown 800 site of Montana Public Safety Communications System. Its control channels are 851.6, 852.775 MHz. Program a control channel first; the scanner finds the voice channels from it.