Skip to content

Washington Fire and EMS Frequencies

We do not have frequencies listed specifically for Washington in Franklin County, Nebraska yet. Countywide channels for Franklin County that may also cover this area are shown below when we have them. The closest trunked radio site we have is Franklin (Nebraska State Radio System), about 9 miles away.

About Washington Fire and EMS Frequencies

Quick answer: County-level fire dispatch that covers Washington: Franklin County Fire 155.9250 MHz, narrow FM, 466 DPL.

  • 2 conventional channels are analog FM, so any scanner can receive them. Enter the frequency and set the tone shown in the table.

Data updated .

Franklin County channels that also cover Washington

Fire Dispatch

Fire Dispatch frequencies for Franklin County
AgencyDescriptionFrequency (MHz)ToneModeFCC
Franklin County FireFranklin County Fire – Dispatch155.9250466 DPLFMNKAG796
Franklin County FireFire Paging462.9500
In 467.9500
FMNWQTG609

Nearest trunked radio sites

Distances are measured from the center of Washington.

Franklin · Nebraska State Radio System
RFSS 1 · Site 71 (hex 47) · about 9 mi away
Control 154.71, 154.98
Voice 154.16, 154.355
Holstein · Adams County
Site 2 (hex 2) · about 31 mi away
Control 453.5125
Voice 453.225, 453.7625
Ayr · Nebraska State Radio System
RFSS 1 · Site 89 (hex 59) · NAC B8F · about 35 mi away
Control 152.51, 152.69
Voice 152.03, 152.18
What do these numbers mean?
Control channel
The frequency your scanner listens to first. It tells the scanner where each voice call is happening, so program it before anything else.
Voice
The other frequencies the site uses for calls. A trunking scanner follows them automatically once it has the control channel.
Site
One tower location of the system. Scanners show the number in decimal or hex, so both are listed.
RFSS (Radio Frequency Sub-System)
A group of sites run by the same controller. Large Project 25 systems can have several.
NAC (Network Access Code)
A hex code the site transmits. Your scanner can use it to ignore other systems on the same frequency.
Talkgroup
A virtual channel on a trunked system, such as one agency’s dispatch. Programming uses the decimal or hex number, depending on your scanner.

Common questions

What frequency does the fire department use in Washington?

We do not have a fire dispatch channel listed specifically for Washington. The county-level fire dispatch channels in the same county: Franklin County Fire 155.9250 MHz, narrow FM, 466 DPL.

What scanner do I need to listen to fire and EMS in Washington?

The analog conventional channels can be heard on any scanner.

What are the control channels for trunked radio in Washington?

For Washington, start with the Franklin site of Nebraska State Radio System. Its control channels are 154.71, 154.98 MHz. Program a control channel first; the scanner finds the voice channels from it.