Skip to content

Kinloss Fire and EMS Frequencies

We do not have frequencies listed specifically for Kinloss in Walsh County, North Dakota yet. Countywide channels for Walsh County that may also cover this area are shown below when we have them. The closest trunked radio site we have is Edmore (North Dakota Statewide Interoperable Radio Network (SIRN 20/20)), about 10 miles away.

About Kinloss Fire and EMS Frequencies

Quick answer: County-level fire dispatch that covers Kinloss: Walsh County Fire 155.0550 MHz, narrow FM, 110.9 PL. Trunked: North Dakota Statewide Interoperable Radio Network (SIRN 20/20), for example Walsh County Fire talkgroup 50205 (hex c41d).

  • 4 conventional channels are analog FM, so any scanner can receive them. Enter the frequency and set the tone shown in the table.
  • 1 conventional channel uses a digital mode (P25), which needs a scanner that decodes that mode.
  • Trunked radio systems that carry fire and EMS traffic here: North Dakota Statewide Interoperable Radio Network (SIRN 20/20): 1 talkgroup. A trunking scanner is required, and it must support the system type shown.
  • To follow a trunked system, program a control channel first. For Kinloss, start with the Edmore site of North Dakota Statewide Interoperable Radio Network (SIRN 20/20), about 10 miles away. Its control channels: 853.6625, 853.8875 MHz.

Data updated .

Walsh County channels that also cover Kinloss

Fire Dispatch

Fire Dispatch frequencies for Walsh County
AgencyDescriptionFrequency (MHz)ToneModeFCC
Walsh County FirePaging EMS/Fire – County Services155.0550
In 158.8350
110.9 PLFMNKNNU593
Walsh County FireCounty Fire/EMS Services155.8200
In 153.9800
NAC 455P25KDV388

Fire Ground / Tactical

Fire Ground / Tactical frequencies for Walsh County
AgencyDescriptionFrequency (MHz)ToneModeFCC
Walsh County FireHoople Fire Department154.0700CSQFMNWNXV602
Walsh County FirePark River Fire Department158.8650FMNWPCH798

EMS Tactical

EMS Tactical frequencies for Walsh County
AgencyDescriptionFrequency (MHz)ToneModeFCC
Walsh County EMSValley Ambulance Service – Grafton155.2800CSQFMNKY7708

North Dakota Statewide Interoperable Radio Network (SIRN 20/20)

North Dakota Statewide Interoperable Radio Network (SIRN 20/20) talkgroups
AgencyDescriptionTalkgroupHexMode
Walsh County FireCounty Fire/EMS Dispatch50205c41dT

Nearest trunked radio sites

Distances are measured from the center of Kinloss.

Edmore · North Dakota Statewide Interoperable Radio Network (SIRN 20/20)
RFSS 1 · Site 92 (hex 5C) · NAC A6B · about 10 mi away
Control 853.6625, 853.8875
Voice 853.4375
Milton · North Dakota Statewide Interoperable Radio Network (SIRN 20/20)
RFSS 1 · Site 29 (hex 1D) · NAC A6C · about 15 mi away
Control 851.8125, 852.3125
Voice 851.5875
Wales · North Dakota Statewide Interoperable Radio Network (SIRN 20/20)
RFSS 1 · Site 42 (hex 2A) · about 21 mi away
Control 853.8625
Voice 853.4125, 853.6375
What do these numbers mean?
Control channel
The frequency your scanner listens to first. It tells the scanner where each voice call is happening, so program it before anything else.
Voice
The other frequencies the site uses for calls. A trunking scanner follows them automatically once it has the control channel.
Site
One tower location of the system. Scanners show the number in decimal or hex, so both are listed.
RFSS (Radio Frequency Sub-System)
A group of sites run by the same controller. Large Project 25 systems can have several.
NAC (Network Access Code)
A hex code the site transmits. Your scanner can use it to ignore other systems on the same frequency.
Talkgroup
A virtual channel on a trunked system, such as one agency’s dispatch. Programming uses the decimal or hex number, depending on your scanner.

Common questions

What frequency does the fire department use in Kinloss?

We do not have a fire dispatch channel listed specifically for Kinloss. The county-level fire dispatch channels in the same county: Walsh County Fire 155.0550 MHz, narrow FM, 110.9 PL.

Do fire departments and EMS use a trunked radio system in Kinloss?

Yes. The county-level systems that cover Kinloss are Fire and EMS talkgroups are listed for North Dakota Statewide Interoperable Radio Network (SIRN 20/20): 1 talkgroup. A trunking scanner is required.

What scanner do I need to listen to fire and EMS in Kinloss?

The analog conventional channels can be heard on any scanner; a scanner that decodes P25 is needed for the digital conventional channels; a trunking scanner is needed for the trunked talkgroups.

What are the control channels for trunked radio in Kinloss?

For Kinloss, start with the Edmore site of North Dakota Statewide Interoperable Radio Network (SIRN 20/20). Its control channels are 853.6625, 853.8875 MHz. Program a control channel first; the scanner finds the voice channels from it.