Skip to content

Washington Fire and EMS Frequencies

We do not have frequencies listed specifically for Washington in Jackson County, Ohio yet. Countywide channels for Jackson County that may also cover this area are shown below when we have them. The closest trunked radio site we have is Jackson (Ohio MARCS-IP: Multi-Agency Radio Communications), about 6 miles away.

About Washington Fire and EMS Frequencies

Quick answer: County-level fire dispatch that covers Washington: Fire/EMS Operations 453.1250 MHz, narrow FM, 506 DPL. County-level ems dispatch that covers Washington: Fire/EMS Operations 453.3125 MHz, narrow FM, 114.8 PL. Trunked: Ohio MARCS-IP: Multi-Agency Radio Communications, for example Jackson County Fire talkgroup 26018 (hex 65a2).

  • 6 conventional channels are analog FM, so any scanner can receive them. Enter the frequency and set the tone shown in the table.
  • 1 conventional channel uses a digital mode (P25), which needs a scanner that decodes that mode.
  • Trunked radio systems that carry fire and EMS traffic here: Ohio MARCS-IP: Multi-Agency Radio Communications: 7 talkgroups. A trunking scanner is required, and it must support the system type shown.
  • To follow a trunked system, program a control channel first. For Washington, start with the Jackson site of Ohio MARCS-IP: Multi-Agency Radio Communications, about 6 miles away. Its control channels: 771.68125, 774.53125 MHz.

Data updated .

Jackson County channels that also cover Washington

Fire Dispatch

Fire Dispatch frequencies for Jackson County
AgencyDescriptionFrequency (MHz)ToneModeFCC
Fire/EMS OperationsMadison-Jefferson Fire (Oak Hill)453.1250
In 458.1250
506 DPLFMNWNAU921
Fire/EMS OperationsWellston Fire Department – Alerting453.5125
In 458.5125
114.8 PLFMNWPZK765
Fire/EMS OperationsFire Operations / Paging – countywide453.6250
In 458.6250
114.8 PLFMNKNAY777

Fire Ground / Tactical

Fire Ground / Tactical frequencies for Jackson County
AgencyDescriptionFrequency (MHz)ToneModeFCC
Fire/EMS OperationsFire Operations – Jackson / Lick Twp451.9750
In 456.9750
114.8 PLFMNWPYQ787
Fire/EMS OperationsFire Operations – Oak Hill / Ham Twp453.2750
In 458.2750
114.8 PLFMNWPDB987
Fire/EMS OperationsFire/EMS vehicular repeaters458.8875NAC 293P25WPDB987

EMS Dispatch

EMS Dispatch frequencies for Jackson County
AgencyDescriptionFrequency (MHz)ToneModeFCC
Fire/EMS OperationsEMS Paging – countywide453.3125
In 458.3125
114.8 PLFMNWPDB987

Ohio MARCS-IP: Multi-Agency Radio Communications

Ohio MARCS-IP: Multi-Agency Radio Communications talkgroups
AgencyDescriptionTalkgroupHexMode
Jackson County FireJackson County Fire – Dispatch2601865a2D
Jackson County FireFire and EMS Paging2603765b5D
Jackson County FireFire Operations260096599D
Jackson County FireJackson County Fire – Fire Ground2601765a1D
Jackson County FireFire Operations2602565a9D
Jackson County FireJackson County Fire – Fire Ground2603565b3D
Jackson County EMSJackson County EMS – Dispatch260046594D

Nearest trunked radio sites

Distances are measured from the center of Washington.

Jackson · Ohio MARCS-IP: Multi-Agency Radio Communications
RFSS 3 · Site 78 (hex 4E) · NAC 34D · about 6 mi away
Control 771.68125, 774.53125
Voice 769.28125, 769.58125, 852.2, 858.6375
Allensville (Vinton) · Ohio MARCS-IP: Multi-Agency Radio Communications
RFSS 3 · Site 73 (hex 49) · NAC 348 · about 9 mi away
Control 774.33125, 774.58125
Voice 770.15625, 851.8875, 852.1125, 852.3875
Indian Camp (Wellston) · Ohio MARCS-IP: Multi-Agency Radio Communications
RFSS 3 · Site 79 (hex 4F) · NAC 34E · about 10 mi away
Control 771.28125, 771.58125
Voice 769.50625, 851.7375, 852.4375, 852.6375
What do these numbers mean?
Control channel
The frequency your scanner listens to first. It tells the scanner where each voice call is happening, so program it before anything else.
Voice
The other frequencies the site uses for calls. A trunking scanner follows them automatically once it has the control channel.
Site
One tower location of the system. Scanners show the number in decimal or hex, so both are listed.
RFSS (Radio Frequency Sub-System)
A group of sites run by the same controller. Large Project 25 systems can have several.
NAC (Network Access Code)
A hex code the site transmits. Your scanner can use it to ignore other systems on the same frequency.
Talkgroup
A virtual channel on a trunked system, such as one agency’s dispatch. Programming uses the decimal or hex number, depending on your scanner.

Common questions

What frequency does the fire department use in Washington?

We do not have a fire dispatch channel listed specifically for Washington. The county-level fire dispatch channels in the same county: Fire/EMS Operations 453.1250 MHz, narrow FM, 506 DPL.

What frequency does EMS or the ambulance service use in Washington?

We do not have a EMS dispatch channel listed specifically for Washington. The county-level EMS dispatch channels in the same county: Fire/EMS Operations 453.3125 MHz, narrow FM, 114.8 PL.

Do fire departments and EMS use a trunked radio system in Washington?

Yes. The county-level systems that cover Washington are Fire and EMS talkgroups are listed for Ohio MARCS-IP: Multi-Agency Radio Communications: 7 talkgroups. A trunking scanner is required.

What scanner do I need to listen to fire and EMS in Washington?

The analog conventional channels can be heard on any scanner; a scanner that decodes P25 is needed for the digital conventional channels; a trunking scanner is needed for the trunked talkgroups.

What are the control channels for trunked radio in Washington?

For Washington, start with the Jackson site of Ohio MARCS-IP: Multi-Agency Radio Communications. Its control channels are 771.68125, 774.53125 MHz. Program a control channel first; the scanner finds the voice channels from it.