Skip to content

Elk Fire and EMS Frequencies

We do not have frequencies listed specifically for Elk in Noble County, Ohio yet. Countywide channels for Noble County that may also cover this area are shown below when we have them. The closest trunked radio site we have is Lewisville (Ohio MARCS-IP: Multi-Agency Radio Communications), about 9 miles away.

About Elk Fire and EMS Frequencies

Quick answer: County-level fire dispatch that covers Elk: Fire and EMS 33.9000 MHz, FM, no tone. County-level ems dispatch that covers Elk: Fire and EMS 154.0850 MHz, narrow FM, 173.8 PL. Trunked: Ohio MARCS-IP: Multi-Agency Radio Communications, for example Noble County Fire talkgroup 37505 (hex 9281).

  • 3 conventional channels are analog FM, so any scanner can receive them. Enter the frequency and set the tone shown in the table.
  • Trunked radio systems that carry fire and EMS traffic here: Ohio MARCS-IP: Multi-Agency Radio Communications: 2 talkgroups. A trunking scanner is required, and it must support the system type shown.
  • To follow a trunked system, program a control channel first. For Elk, start with the Lewisville site of Ohio MARCS-IP: Multi-Agency Radio Communications, about 9 miles away. Its control channels: 771.63125, 772.10625 MHz.

Data updated .

Noble County channels that also cover Elk

Fire Dispatch

Fire Dispatch frequencies for Noble County
AgencyDescriptionFrequency (MHz)ToneModeFCC
Fire and EMSNoble County Fire dispatch (including Belle Valley, Caldwell, and Summerfield)33.9000FMKNFQ946

EMS Dispatch

EMS Dispatch frequencies for Noble County
AgencyDescriptionFrequency (MHz)ToneModeFCC
Fire and EMSUnited Ambulance Dispatch154.0850
In 159.3000
173.8 PLFMNKNJU589

EMS Tactical

EMS Tactical frequencies for Noble County
AgencyDescriptionFrequency (MHz)ToneModeFCC
Fire and EMSUnited Ambulance Operations155.1600173.8 PLFMNKNJU589

Ohio MARCS-IP: Multi-Agency Radio Communications

Ohio MARCS-IP: Multi-Agency Radio Communications talkgroups
AgencyDescriptionTalkgroupHexMode
Noble County FireNoble County Fire – Dispatch375059281D
Noble County EMSNoble County EMS – Dispatch375049280D

Nearest trunked radio sites

Distances are measured from the center of Elk.

Lewisville · Ohio MARCS-IP: Multi-Agency Radio Communications
RFSS 3 · Site 32 (hex 20) · NAC 34F · about 9 mi away
Control 771.63125, 772.10625
Voice 770.03125, 771.35625, 854.3875, 855.7375
Noble C.I. (Caldwell) · Ohio MARCS-IP: Multi-Agency Radio Communications
RFSS 3 · Site 2 (hex 2) · NAC 341 · about 14 mi away
Control 774.03125, 774.38125
Voice 769.93125, 772.63125, 854.6625
Washington County Simulcast · Ohio MARCS-IP: Multi-Agency Radio Communications
RFSS 3 · Site 7 (hex 7) · NAC 347 · about 15 mi away
Control 773.73125, 774.43125
Voice 772.28125, 772.88125, 773.13125, 773.38125
What do these numbers mean?
Control channel
The frequency your scanner listens to first. It tells the scanner where each voice call is happening, so program it before anything else.
Voice
The other frequencies the site uses for calls. A trunking scanner follows them automatically once it has the control channel.
Site
One tower location of the system. Scanners show the number in decimal or hex, so both are listed.
RFSS (Radio Frequency Sub-System)
A group of sites run by the same controller. Large Project 25 systems can have several.
NAC (Network Access Code)
A hex code the site transmits. Your scanner can use it to ignore other systems on the same frequency.
Talkgroup
A virtual channel on a trunked system, such as one agency’s dispatch. Programming uses the decimal or hex number, depending on your scanner.

Common questions

What frequency does the fire department use in Elk?

We do not have a fire dispatch channel listed specifically for Elk. The county-level fire dispatch channels in the same county: Fire and EMS 33.9000 MHz, FM, no tone.

What frequency does EMS or the ambulance service use in Elk?

We do not have a EMS dispatch channel listed specifically for Elk. The county-level EMS dispatch channels in the same county: Fire and EMS 154.0850 MHz, narrow FM, 173.8 PL.

Do fire departments and EMS use a trunked radio system in Elk?

Yes. The county-level systems that cover Elk are Fire and EMS talkgroups are listed for Ohio MARCS-IP: Multi-Agency Radio Communications: 2 talkgroups. A trunking scanner is required.

What scanner do I need to listen to fire and EMS in Elk?

The analog conventional channels can be heard on any scanner; a trunking scanner is needed for the trunked talkgroups.

What are the control channels for trunked radio in Elk?

For Elk, start with the Lewisville site of Ohio MARCS-IP: Multi-Agency Radio Communications. Its control channels are 771.63125, 772.10625 MHz. Program a control channel first; the scanner finds the voice channels from it.