Skip to content

Ramsey Fire and EMS Frequencies

We do not have frequencies listed specifically for Ramsey in McCook County, South Dakota yet. Countywide channels for McCook County that may also cover this area are shown below when we have them. The closest trunked radio site we have is Madison (South Dakota State Radio System), about 10 miles away.

About Ramsey Fire and EMS Frequencies

Quick answer: Trunked: South Dakota State Radio System, for example McCook County Fire talkgroup 1024 (hex 400).

  • 4 conventional channels are analog FM, so any scanner can receive them. Enter the frequency and set the tone shown in the table.
  • Trunked radio systems that carry fire and EMS traffic here: South Dakota State Radio System: 2 talkgroups. A trunking scanner is required, and it must support the system type shown.
  • To follow a trunked system, program a control channel first. For Ramsey, start with the Madison site of South Dakota State Radio System, about 10 miles away. Its control channels: 159.78, 160.065 MHz.

Data updated .

McCook County channels that also cover Ramsey

Fire Ground / Tactical

Fire Ground / Tactical frequencies for McCook County
AgencyDescriptionFrequency (MHz)ToneModeFCC
McCook County FireCanistota Fire154.2050162.2 PLFMWQFE379
McCook County FireSpencer Fire154.3100131.8 PLFMWPMT426
McCook County FireSalem Fireground453.7375FMNWQRS390

EMS Tactical

EMS Tactical frequencies for McCook County
AgencyDescriptionFrequency (MHz)ToneModeFCC
McCook County EMSMcCook County EMS – Tactical Channel464.7500
In 469.7500
97.4 PLFMWPCS593

South Dakota State Radio System

South Dakota State Radio System talkgroups
AgencyDescriptionTalkgroupHexMode
McCook County FireMcCook County Fire – Dispatch1024400D
McCook County EMSMcCook County EMS – Dispatch1027403D

Nearest trunked radio sites

Distances are measured from the center of Ramsey.

Madison · South Dakota State Radio System
RFSS 1 · Site 28 (hex 1C) · NAC 47C · about 10 mi away
Control 159.78, 160.065
Voice 159.54, 159.915
Minnehaha Simulcast · South Dakota State Radio System
RFSS 1 · Site 61 (hex 3D) · NAC 479 · about 20 mi away
Control 157.2625, 157.755
Voice 157.95, 158.49, 158.64
Wall Lake · South Dakota State Radio System
RFSS 1 · Site 5 (hex 5) · about 21 mi away
Control 155.7, 157.4125, 157.7025
Voice 156.015, 159.615, 159.855, 160.155
What do these numbers mean?
Control channel
The frequency your scanner listens to first. It tells the scanner where each voice call is happening, so program it before anything else.
Voice
The other frequencies the site uses for calls. A trunking scanner follows them automatically once it has the control channel.
Site
One tower location of the system. Scanners show the number in decimal or hex, so both are listed.
RFSS (Radio Frequency Sub-System)
A group of sites run by the same controller. Large Project 25 systems can have several.
NAC (Network Access Code)
A hex code the site transmits. Your scanner can use it to ignore other systems on the same frequency.
Talkgroup
A virtual channel on a trunked system, such as one agency’s dispatch. Programming uses the decimal or hex number, depending on your scanner.

Common questions

Do fire departments and EMS use a trunked radio system in Ramsey?

Yes. The county-level systems that cover Ramsey are Fire and EMS talkgroups are listed for South Dakota State Radio System: 2 talkgroups. A trunking scanner is required.

What scanner do I need to listen to fire and EMS in Ramsey?

The analog conventional channels can be heard on any scanner; a trunking scanner is needed for the trunked talkgroups.

What are the control channels for trunked radio in Ramsey?

For Ramsey, start with the Madison site of South Dakota State Radio System. Its control channels are 159.78, 160.065 MHz. Program a control channel first; the scanner finds the voice channels from it.