Skip to content

Cedar Highlands Fire and EMS Frequencies

We do not have frequencies listed specifically for Cedar Highlands in Iron County, Utah yet. Countywide channels for Iron County that may also cover this area are shown below when we have them. The closest trunked radio site we have is Windy Ridge (Utah Communications Authority (P25)), about 7 miles away.

About Cedar Highlands Fire and EMS Frequencies

Quick answer: County-level fire dispatch that covers Cedar Highlands: Iron County Fire 154.2575 MHz, narrow FM, no tone. Trunked: Utah Communications Authority (P25) (Project 25), for example Iron County Fire talkgroup 8004 (hex 1f44).

  • 2 conventional channels are analog FM, so any scanner can receive them. Enter the frequency and set the tone shown in the table.
  • Trunked radio systems that carry fire and EMS traffic here: Utah Communications Authority (P25) (Project 25): 11 talkgroups. A trunking scanner is required, and it must support the system type shown.
  • To follow a trunked system, program a control channel first. For Cedar Highlands, start with the Windy Ridge site of Utah Communications Authority (P25), about 7 miles away. Its control channels: 769.76875, 774.79375 MHz.

Data updated .

Iron County channels that also cover Cedar Highlands

Fire Dispatch

Fire Dispatch frequencies for Iron County
AgencyDescriptionFrequency (MHz)ToneModeFCC
Iron County FireIron County Fire – Dispatch154.2575
In 156.2250
FMNWQGI234

EMS Talk-around

EMS Talk-around frequencies for Iron County
AgencyDescriptionFrequency (MHz)ToneModeFCC
Iron County EMSIron County EMS – Alternate155.2650203.5 PLFMNKNGU697

Utah Communications Authority (P25)

Project 25 · System ID 00A

Utah Communications Authority (P25) talkgroups
AgencyDescriptionTalkgroupHexMode
Iron County FireFire-EMS Paging 800480041f44T
Iron County FireFire-EMS Paging 800880081f48T
Iron County FireIron County Fire – Dispatch80321f60T
Iron County FireOperations80291f5dT
Iron County FireIron County Fire – Fire Ground80331f61T
Iron County FireIron County Fire – Tactical Channel80351f63T
Iron County FireIron County Fire – Tactical Channel80361f64T
Iron County FireEvent80371f65T
Iron County FireIron County Fire – Alternate80341f62T
Iron County FireSearch and Rescue80421f6aT
Iron County FireSearch and Rescue80431f6bT

Nearest trunked radio sites

Distances are measured from the center of Cedar Highlands.

Windy Ridge · Utah Communications Authority (P25)
Project 25 · RFSS 121 · Site 121 (hex 79) · NAC 209 · about 7 mi away
Control 769.76875, 774.79375
Voice 770.69375, 771.13125, 772.36875, 773.05625, 773.59375, 774.06875
Rudds Roost · Utah Communications Authority (P25)
Project 25 · RFSS 91 · Site 91 (hex 5B) · NAC FFB · about 23 mi away
Control 771.06875, 772.96875
Voice 772.53125
Toquerville Heights · Utah Communications Authority (P25)
Project 25 · RFSS 105 · Site 105 (hex 69) · NAC 1F9 · about 27 mi away
Control 769.26875, 774.43125
Voice 769.56875, 771.94375, 772.24375, 772.44375, 772.69375, 773.91875
What do these numbers mean?
Control channel
The frequency your scanner listens to first. It tells the scanner where each voice call is happening, so program it before anything else.
Voice
The other frequencies the site uses for calls. A trunking scanner follows them automatically once it has the control channel.
Site
One tower location of the system. Scanners show the number in decimal or hex, so both are listed.
RFSS (Radio Frequency Sub-System)
A group of sites run by the same controller. Large Project 25 systems can have several.
NAC (Network Access Code)
A hex code the site transmits. Your scanner can use it to ignore other systems on the same frequency.
Talkgroup
A virtual channel on a trunked system, such as one agency’s dispatch. Programming uses the decimal or hex number, depending on your scanner.

Common questions

What frequency does the fire department use in Cedar Highlands?

We do not have a fire dispatch channel listed specifically for Cedar Highlands. The county-level fire dispatch channels in the same county: Iron County Fire 154.2575 MHz, narrow FM, no tone.

Do fire departments and EMS use a trunked radio system in Cedar Highlands?

Yes. The county-level systems that cover Cedar Highlands are Fire and EMS talkgroups are listed for Utah Communications Authority (P25) (Project 25): 11 talkgroups. A trunking scanner is required.

What scanner do I need to listen to fire and EMS in Cedar Highlands?

The analog conventional channels can be heard on any scanner; a trunking scanner that supports Project 25 is needed for the trunked talkgroups.

What are the control channels for trunked radio in Cedar Highlands?

For Cedar Highlands, start with the Windy Ridge site of Utah Communications Authority (P25). Its control channels are 769.76875, 774.79375 MHz. Program a control channel first; the scanner finds the voice channels from it.