Skip to content

El Rancho Fire and EMS Frequencies

We do not have frequencies listed specifically for El Rancho in Platte County, Wyoming yet. Countywide channels for Platte County that may also cover this area are shown below when we have them. The closest trunked radio site we have is Pine Ridge (WyoLink), about 5 miles away.

About El Rancho Fire and EMS Frequencies

Quick answer: County-level fire dispatch that covers El Rancho: Platte County Fire 155.8050 MHz, narrow FM, 110.9 PL. Trunked: WyoLink, for example Platte County Fire talkgroup 1206 (hex 4b6).

  • 1 conventional channel is analog FM, so any scanner can receive it. Enter the frequency and set the tone shown in the table.
  • Trunked radio systems that carry fire and EMS traffic here: WyoLink: 8 talkgroups. A trunking scanner is required, and it must support the system type shown.
  • To follow a trunked system, program a control channel first. For El Rancho, start with the Pine Ridge site of WyoLink, about 5 miles away. Its control channels: 151.055, 156.2025 MHz.

Data updated .

Platte County channels that also cover El Rancho

Fire Dispatch

Fire Dispatch frequencies for Platte County
AgencyDescriptionFrequency (MHz)ToneModeFCC
Platte County FirePlatte County Fire – Dispatch155.8050
In 153.7850
110.9 PLFMNKXQ975

WyoLink

WyoLink talkgroups
AgencyDescriptionTalkgroupHexMode
Platte County FirePlatte County Fire – Dispatch12064b6D
Platte County FirePlatte County Fire – Tactical Channel12074b7D
Platte County FirePlatte County Fire – Tactical Channel12084b8D
Platte County FireAntelope Gap Fire12134bdD
Platte County FirePalmer Canyon Fire12254c9D
Platte County FirePlatte County Fire – Fire Ground12284ccD
Platte County EMSPlatte County EMS – Dispatch12094b9D
Platte County EMSPlatte County EMS – Tactical Channel12104baD

Nearest trunked radio sites

Distances are measured from the center of El Rancho.

Pine Ridge · WyoLink
RFSS 2 · Site 2 (hex 2) · NAC 1A0 · about 5 mi away
Control 151.055, 156.2025
Voice 150.92, 151.205, 153.6425
Wheatland · WyoLink
RFSS 1 · Site 39 (hex 27) · NAC 1A9 · about 15 mi away
Control 150.9725, 151.1225
Voice 155.175, 161.825, 161.85
Virgin Hill · WyoLink
RFSS 1 · Site 31 (hex 1F) · NAC 1A0 · about 24 mi away
Control 151.2575, 153.8975
Voice 151.2725, 153.95, 154.3025
What do these numbers mean?
Control channel
The frequency your scanner listens to first. It tells the scanner where each voice call is happening, so program it before anything else.
Voice
The other frequencies the site uses for calls. A trunking scanner follows them automatically once it has the control channel.
Site
One tower location of the system. Scanners show the number in decimal or hex, so both are listed.
RFSS (Radio Frequency Sub-System)
A group of sites run by the same controller. Large Project 25 systems can have several.
NAC (Network Access Code)
A hex code the site transmits. Your scanner can use it to ignore other systems on the same frequency.
Talkgroup
A virtual channel on a trunked system, such as one agency’s dispatch. Programming uses the decimal or hex number, depending on your scanner.

Common questions

What frequency does the fire department use in El Rancho?

We do not have a fire dispatch channel listed specifically for El Rancho. The county-level fire dispatch channels in the same county: Platte County Fire 155.8050 MHz, narrow FM, 110.9 PL.

Do fire departments and EMS use a trunked radio system in El Rancho?

Yes. The county-level systems that cover El Rancho are Fire and EMS talkgroups are listed for WyoLink: 8 talkgroups. A trunking scanner is required.

What scanner do I need to listen to fire and EMS in El Rancho?

The analog conventional channels can be heard on any scanner; a trunking scanner is needed for the trunked talkgroups.

What are the control channels for trunked radio in El Rancho?

For El Rancho, start with the Pine Ridge site of WyoLink. Its control channels are 151.055, 156.2025 MHz. Program a control channel first; the scanner finds the voice channels from it.