Skip to content

Howard Fire and EMS Frequencies

We do not have frequencies listed specifically for Howard in Taylor County, Georgia yet. Countywide channels for Taylor County that may also cover this area are shown below when we have them. The closest trunked radio site we have is Columbus (Muscogee County Government (GA)), about 29 miles away.

About Howard Fire and EMS Frequencies

Quick answer: County-level fire dispatch that covers Howard: Taylor County Fire 154.2650 MHz, narrow FM, no tone (expired).

  • 1 conventional channel is analog FM, so any scanner can receive it. Enter the frequency and set the tone shown in the table.
  • 1 entry is marked expired, so it may no longer be in use.

Data updated .

Taylor County channels that also cover Howard

Fire Dispatch

Fire Dispatch frequencies for Taylor County
AgencyDescriptionFrequency (MHz)ToneModeFCC
Taylor County Fire Expired: Expired 6/23Taylor County Fire – Dispatch154.2650
In 156.0600
FMNWPMD480

Nearest trunked radio sites

Distances are measured from the center of Howard.

Columbus · Muscogee County Government (GA)
RFSS 7 · Site 3 (hex 3) · NAC 393 · about 29 mi away
Control 851.6125, 852.0875, 852.1125, 852.375
Voice 852.8375, 853.1375, 853.1625, 853.825, 854.0875, 854.4375, 854.7375, 854.9875, 855.3875, 855.5125, 855.7125, 855.9875, 856.3125, 856.4375, 856.7125, 856.8875, 856.9875, 857.3375, 857.4625
Zebulon · Pike County Public Safety
Site 3 (hex 3) · about 33 mi away
Voice 460.4125
Concord · Pike County Public Safety
Site 1 (hex 1) · about 33 mi away
Voice 460.1625
What do these numbers mean?
Control channel
The frequency your scanner listens to first. It tells the scanner where each voice call is happening, so program it before anything else.
Voice
The other frequencies the site uses for calls. A trunking scanner follows them automatically once it has the control channel.
Site
One tower location of the system. Scanners show the number in decimal or hex, so both are listed.
RFSS (Radio Frequency Sub-System)
A group of sites run by the same controller. Large Project 25 systems can have several.
NAC (Network Access Code)
A hex code the site transmits. Your scanner can use it to ignore other systems on the same frequency.
Talkgroup
A virtual channel on a trunked system, such as one agency’s dispatch. Programming uses the decimal or hex number, depending on your scanner.

Common questions

What frequency does the fire department use in Howard?

We do not have a fire dispatch channel listed specifically for Howard. The county-level fire dispatch channels in the same county: Taylor County Fire 154.2650 MHz, narrow FM, no tone (expired).

What scanner do I need to listen to fire and EMS in Howard?

The analog conventional channels can be heard on any scanner.

What are the control channels for trunked radio in Howard?

For Howard, start with the Columbus site of Muscogee County Government (GA). Its control channels are 851.6125, 852.0875, 852.1125, 852.375 MHz. Program a control channel first; the scanner finds the voice channels from it.