Skip to content

Wabash Fire and EMS Frequencies

We do not have frequencies listed specifically for Wabash in Fountain County, Indiana yet. Countywide channels for Fountain County that may also cover this area are shown below when we have them. The closest trunked radio site we have is Covington (Indiana Project Hoosier SAFE-T), about 6 miles away.

About Wabash Fire and EMS Frequencies

Quick answer: County-level fire dispatch that covers Wabash: Emergency Management/Fire/EMS 154.4300 MHz, narrow FM, 107.2 PL. County-level ems dispatch that covers Wabash: Emergency Management/Fire/EMS 155.9550 MHz, narrow FM, 146.2 PL. Trunked: Indiana Project Hoosier SAFE-T, for example Fountain County EMS talkgroup 10257 (hex 2811).

  • 4 conventional channels are analog FM, so any scanner can receive them. Enter the frequency and set the tone shown in the table.
  • Trunked radio systems that carry fire and EMS traffic here: Indiana Project Hoosier SAFE-T: 2 talkgroups. A trunking scanner is required, and it must support the system type shown.
  • To follow a trunked system, program a control channel first. For Wabash, start with the Covington site of Indiana Project Hoosier SAFE-T, about 6 miles away. Its control channels: 853.3625, 853.9 MHz.

Data updated .

Fountain County channels that also cover Wabash

Fire Dispatch

Fire Dispatch frequencies for Fountain County
AgencyDescriptionFrequency (MHz)ToneModeFCC
Emergency Management/Fire/EMSEmergency Management/Fire/EMS – Dispatch154.4300
In 159.0525
107.2 PLFMNWPLS514

Fire Ground / Tactical

Fire Ground / Tactical frequencies for Fountain County
AgencyDescriptionFrequency (MHz)ToneModeFCC
Emergency Management/Fire/EMSEmergency Management/Fire/EMS – Tactical Channel153.9500FMNWPKY952
Emergency Management/Fire/EMSEmergency Management Operations453.1750
In 458.1750
114.8 PLFMNWQIW312

EMS Dispatch

EMS Dispatch frequencies for Fountain County
AgencyDescriptionFrequency (MHz)ToneModeFCC
Emergency Management/Fire/EMSEmergency Management/Fire/EMS – Dispatch155.9550146.2 PLFMNKNDK594

Indiana Project Hoosier SAFE-T

Indiana Project Hoosier SAFE-T talkgroups
AgencyDescriptionTalkgroupHexMode
Fountain County EMSFountain County EMS – Dispatch102572811D
Fountain County EMSFountain County EMS – Tactical Channel102582812D

Nearest trunked radio sites

Distances are measured from the center of Wabash.

Covington · Indiana Project Hoosier SAFE-T
RFSS 1 · Site 26 (hex 1A) · NAC 6B6 · about 6 mi away
Control 853.3625, 853.9
Voice 851.3625, 852.3625, 852.8625, 855.2375
Newport · Indiana Project Hoosier SAFE-T
RFSS 1 · Site 27 (hex 1B) · NAC 6B2 · about 9 mi away
Control 857.9625, 858.5125, 859.9625
Voice 851.975, 858.9625
Attica · Indiana Project Hoosier SAFE-T
RFSS 1 · Site 67 (hex 43) · NAC 6B8 · about 17 mi away
Control 853.4375, 853.9375
Voice 851.4125, 851.9125, 852.9125, 856.2375
What do these numbers mean?
Control channel
The frequency your scanner listens to first. It tells the scanner where each voice call is happening, so program it before anything else.
Voice
The other frequencies the site uses for calls. A trunking scanner follows them automatically once it has the control channel.
Site
One tower location of the system. Scanners show the number in decimal or hex, so both are listed.
RFSS (Radio Frequency Sub-System)
A group of sites run by the same controller. Large Project 25 systems can have several.
NAC (Network Access Code)
A hex code the site transmits. Your scanner can use it to ignore other systems on the same frequency.
Talkgroup
A virtual channel on a trunked system, such as one agency’s dispatch. Programming uses the decimal or hex number, depending on your scanner.

Common questions

What frequency does the fire department use in Wabash?

We do not have a fire dispatch channel listed specifically for Wabash. The county-level fire dispatch channels in the same county: Emergency Management/Fire/EMS 154.4300 MHz, narrow FM, 107.2 PL.

What frequency does EMS or the ambulance service use in Wabash?

We do not have a EMS dispatch channel listed specifically for Wabash. The county-level EMS dispatch channels in the same county: Emergency Management/Fire/EMS 155.9550 MHz, narrow FM, 146.2 PL.

Do fire departments and EMS use a trunked radio system in Wabash?

Yes. The county-level systems that cover Wabash are Fire and EMS talkgroups are listed for Indiana Project Hoosier SAFE-T: 2 talkgroups. A trunking scanner is required.

What scanner do I need to listen to fire and EMS in Wabash?

The analog conventional channels can be heard on any scanner; a trunking scanner is needed for the trunked talkgroups.

What are the control channels for trunked radio in Wabash?

For Wabash, start with the Covington site of Indiana Project Hoosier SAFE-T. Its control channels are 853.3625, 853.9 MHz. Program a control channel first; the scanner finds the voice channels from it.