Skip to content

Widner Fire and EMS Frequencies

We do not have frequencies listed specifically for Widner in Knox County, Indiana yet. Countywide channels for Knox County that may also cover this area are shown below when we have them. The closest trunked radio site we have is Edwardsport (Indiana Project Hoosier SAFE-T), about 6 miles away.

About Widner Fire and EMS Frequencies

Quick answer: County-level fire dispatch that covers Widner: County Fire Dispatch 155.8350 MHz, narrow FM, 123.0 PL. Trunked: Indiana Project Hoosier SAFE-T, for example Knox County Fire talkgroup 21434 (hex 53ba).

  • 6 conventional channels are analog FM, so any scanner can receive them. Enter the frequency and set the tone shown in the table.
  • Trunked radio systems that carry fire and EMS traffic here: Indiana Project Hoosier SAFE-T: 10 talkgroups. A trunking scanner is required, and it must support the system type shown.
  • To follow a trunked system, program a control channel first. For Widner, start with the Edwardsport site of Indiana Project Hoosier SAFE-T, about 6 miles away. Its control channels: 857.9625, 860.7625 MHz.

Data updated .

Knox County channels that also cover Widner

Fire Dispatch

Fire Dispatch frequencies for Knox County
AgencyDescriptionFrequency (MHz)ToneModeFCC
County Fire DispatchCounty Fire Dispatch155.8350
In 158.8800
123.0 PLFMNKMK373

Fire Ground / Tactical

Fire Ground / Tactical frequencies for Knox County
AgencyDescriptionFrequency (MHz)ToneModeFCC
Harrison Twp FireHarrison Twp Fire154.0850
In 159.1200
FMNWQKZ407
Johnson Township FireJohnson Township Fire460.4000
In 465.4000
FMNKNEZ467
Knox County Fire800Mhz Backup Repeater854.9875
In 809.9875
156.7 PLFMNWPLQ822
Palmyra Township FirePalmyra Township Fire154.3250FMNKNGQ574
Vigo Township FireVigo Township Fire154.3850
In 158.8950
FMNWZM743

Indiana Project Hoosier SAFE-T

Indiana Project Hoosier SAFE-T talkgroups
AgencyDescriptionTalkgroupHexMode
Knox County FireCounty Fire Multigroup2143453baD
Knox County FireFire/EMS Backup (Site Trunking Mode)2145953d3D
Knox County FireHarrison Township Fire2144253c2D
Knox County FirePalmyra Township Fire2146153d5D
Knox County FireSteen Township Fire2146253d6D
Knox County FireVincennes Township Fire2146553d9D
Knox County FireVigo Township Fire2146653daD
Knox County FireWashington Township Fire2146953ddD
Knox County EMSGood Samaritan EMS2144553c5D
Knox County HospitalGood Samaritan Hospital2144653c6D

Nearest trunked radio sites

Distances are measured from the center of Widner.

Edwardsport · Indiana Project Hoosier SAFE-T
RFSS 2 · Site 20 (hex 14) · NAC 6B1 · about 6 mi away
Control 857.9625, 860.7625
Voice 852.3625, 853.9375, 856.9625
Paxton · Indiana Project Hoosier SAFE-T
RFSS 1 · Site 86 (hex 56) · NAC 6BA · about 11 mi away
Control 852.9125, 853.4125
Voice 851.4125, 851.9125, 852.4125
Linton · Indiana Project Hoosier SAFE-T
RFSS 2 · Site 61 (hex 3D) · NAC 6B6 · about 15 mi away
Control 853.75, 859.7375
Voice 851.975, 852.4625, 852.9625
What do these numbers mean?
Control channel
The frequency your scanner listens to first. It tells the scanner where each voice call is happening, so program it before anything else.
Voice
The other frequencies the site uses for calls. A trunking scanner follows them automatically once it has the control channel.
Site
One tower location of the system. Scanners show the number in decimal or hex, so both are listed.
RFSS (Radio Frequency Sub-System)
A group of sites run by the same controller. Large Project 25 systems can have several.
NAC (Network Access Code)
A hex code the site transmits. Your scanner can use it to ignore other systems on the same frequency.
Talkgroup
A virtual channel on a trunked system, such as one agency’s dispatch. Programming uses the decimal or hex number, depending on your scanner.

Common questions

What frequency does the fire department use in Widner?

We do not have a fire dispatch channel listed specifically for Widner. The county-level fire dispatch channels in the same county: County Fire Dispatch 155.8350 MHz, narrow FM, 123.0 PL.

Do fire departments and EMS use a trunked radio system in Widner?

Yes. The county-level systems that cover Widner are Fire and EMS talkgroups are listed for Indiana Project Hoosier SAFE-T: 10 talkgroups. A trunking scanner is required.

What scanner do I need to listen to fire and EMS in Widner?

The analog conventional channels can be heard on any scanner; a trunking scanner is needed for the trunked talkgroups.

What are the control channels for trunked radio in Widner?

For Widner, start with the Edwardsport site of Indiana Project Hoosier SAFE-T. Its control channels are 857.9625, 860.7625 MHz. Program a control channel first; the scanner finds the voice channels from it.