Skip to content

Pike Fire and EMS Frequencies

We do not have frequencies listed specifically for Pike in Ohio County, Indiana yet. Countywide channels for Ohio County that may also cover this area are shown below when we have them. The closest trunked radio site we have is Aurora (Indiana Project Hoosier SAFE-T), about 9 miles away.

About Pike Fire and EMS Frequencies

Quick answer: Trunked: Indiana Project Hoosier SAFE-T, for example Ohio County Fire talkgroup 21544 (hex 5428).

  • Trunked radio systems that carry fire and EMS traffic here: Indiana Project Hoosier SAFE-T: 4 talkgroups. A trunking scanner is required, and it must support the system type shown.
  • To follow a trunked system, program a control channel first. For Pike, start with the Aurora site of Indiana Project Hoosier SAFE-T, about 9 miles away. Its control channels: 852.4, 857.2125, 858.2125 MHz.

Data updated .

Ohio County channels that also cover Pike

Indiana Project Hoosier SAFE-T

Indiana Project Hoosier SAFE-T talkgroups
AgencyDescriptionTalkgroupHexMode
Ohio County FireOhio County Fire – Dispatch215445428D
Ohio County FireOhio County Fire – Operations215455429D
Ohio County FireOhio County Fire – Operations21546542aD
Ohio County EMSOhio County EMS – Operations215395423D

Nearest trunked radio sites

Distances are measured from the center of Pike.

Aurora · Indiana Project Hoosier SAFE-T
RFSS 2 · Site 43 (hex 2B) · NAC 6B4 · about 9 mi away
Control 852.4, 857.2125, 858.2125, 859.2125
Voice 851.4
Rising Sun · Indiana Project Hoosier SAFE-T
RFSS 2 · Site 37 (hex 25) · NAC 6B3 · about 11 mi away
Control 853.7375, 856.2125
Voice 853.3125, 853.4875
Vevay · Indiana Project Hoosier SAFE-T
RFSS 2 · Site 38 (hex 26) · NAC 6B3 · about 12 mi away
Control 853.675, 853.9625, 854.3375
Voice 851.1, 851.9375
What do these numbers mean?
Control channel
The frequency your scanner listens to first. It tells the scanner where each voice call is happening, so program it before anything else.
Voice
The other frequencies the site uses for calls. A trunking scanner follows them automatically once it has the control channel.
Site
One tower location of the system. Scanners show the number in decimal or hex, so both are listed.
RFSS (Radio Frequency Sub-System)
A group of sites run by the same controller. Large Project 25 systems can have several.
NAC (Network Access Code)
A hex code the site transmits. Your scanner can use it to ignore other systems on the same frequency.
Talkgroup
A virtual channel on a trunked system, such as one agency’s dispatch. Programming uses the decimal or hex number, depending on your scanner.

Common questions

Do fire departments and EMS use a trunked radio system in Pike?

Yes. The county-level systems that cover Pike are Fire and EMS talkgroups are listed for Indiana Project Hoosier SAFE-T: 4 talkgroups. A trunking scanner is required.

What scanner do I need to listen to fire and EMS in Pike?

A trunking scanner is needed for the trunked talkgroups.

What are the control channels for trunked radio in Pike?

For Pike, start with the Aurora site of Indiana Project Hoosier SAFE-T. Its control channels are 852.4, 857.2125, 858.2125, 859.2125 MHz. Program a control channel first; the scanner finds the voice channels from it.