Skip to content

Sherman Fire and EMS Frequencies

We do not have frequencies listed specifically for Sherman in Washington County, Kansas yet. Countywide channels for Washington County that may also cover this area are shown below when we have them. The closest trunked radio site we have is Haddam (Kansas Statewide Interoperable Communication System (KSICS)), about 16 miles away.

About Sherman Fire and EMS Frequencies

Quick answer: County-level fire dispatch that covers Sherman: Washington County Fire 154.8000 MHz, narrow FM, no tone. Trunked: Kansas Statewide Interoperable Communication System (KSICS), for example Washington County Fire talkgroup 4807 (hex 12c7).

  • 3 conventional channels are analog FM, so any scanner can receive them. Enter the frequency and set the tone shown in the table.
  • Trunked radio systems that carry fire and EMS traffic here: Kansas Statewide Interoperable Communication System (KSICS): 2 talkgroups. A trunking scanner is required, and it must support the system type shown.
  • To follow a trunked system, program a control channel first. For Sherman, start with the Haddam site of Kansas Statewide Interoperable Communication System (KSICS), about 16 miles away. Its control channels: 852.4625, 852.725 MHz.

Data updated .

Washington County channels that also cover Sherman

Fire Dispatch

Fire Dispatch frequencies for Washington County
AgencyDescriptionFrequency (MHz)ToneModeFCC
Washington County FireWashington County Fire – Dispatch154.8000
In 159.1950
FMNWNPU316

Fire Ground / Tactical

Fire Ground / Tactical frequencies for Washington County
AgencyDescriptionFrequency (MHz)ToneModeFCC
Washington County FireWashington County Fire – Fire Ground /Tactical154.0700FMNWPLS377
Washington County FireWashington County Fire – Tactical Channel155.775077.0 PLFMNWNPU316

Kansas Statewide Interoperable Communication System (KSICS)

Kansas Statewide Interoperable Communication System (KSICS) talkgroups
AgencyDescriptionTalkgroupHexMode
Washington County FireWashington County Fire – Dispatch480712c7D
Washington County EMSWashington County EMS – Dispatch480812c8D

Nearest trunked radio sites

Distances are measured from the center of Sherman.

Haddam · Kansas Statewide Interoperable Communication System (KSICS)
RFSS 2 · Site 19 (hex 13) · NAC 1B4 · about 16 mi away
Control 852.4625, 852.725
Voice 851.8375, 852.975, 853.4, 853.8625
Randolph · Riley County
RFSS 33 · Site 33 (hex 21) · NAC 021 · about 19 mi away
Control 851.1375, 851.475, 852.5875, 853.3
Riley · Riley County
RFSS 31 · Site 31 (hex 1F) · NAC 01F · about 25 mi away
Control 851.0875, 851.4, 851.95, 852.2875
What do these numbers mean?
Control channel
The frequency your scanner listens to first. It tells the scanner where each voice call is happening, so program it before anything else.
Voice
The other frequencies the site uses for calls. A trunking scanner follows them automatically once it has the control channel.
Site
One tower location of the system. Scanners show the number in decimal or hex, so both are listed.
RFSS (Radio Frequency Sub-System)
A group of sites run by the same controller. Large Project 25 systems can have several.
NAC (Network Access Code)
A hex code the site transmits. Your scanner can use it to ignore other systems on the same frequency.
Talkgroup
A virtual channel on a trunked system, such as one agency’s dispatch. Programming uses the decimal or hex number, depending on your scanner.

Common questions

What frequency does the fire department use in Sherman?

We do not have a fire dispatch channel listed specifically for Sherman. The county-level fire dispatch channels in the same county: Washington County Fire 154.8000 MHz, narrow FM, no tone.

Do fire departments and EMS use a trunked radio system in Sherman?

Yes. The county-level systems that cover Sherman are Fire and EMS talkgroups are listed for Kansas Statewide Interoperable Communication System (KSICS): 2 talkgroups. A trunking scanner is required.

What scanner do I need to listen to fire and EMS in Sherman?

The analog conventional channels can be heard on any scanner; a trunking scanner is needed for the trunked talkgroups.

What are the control channels for trunked radio in Sherman?

For Sherman, start with the Haddam site of Kansas Statewide Interoperable Communication System (KSICS). Its control channels are 852.4625, 852.725 MHz. Program a control channel first; the scanner finds the voice channels from it.