Skip to content

Alberta Fire and EMS Frequencies

We do not have frequencies listed specifically for Alberta in Benton County, Minnesota yet. Countywide channels for Benton County that may also cover this area are shown below when we have them. The closest trunked radio site we have is Gilman - Simulcast (Allied Radio Matrix for Emergency Response (ARMER)), about 12 miles away.

About Alberta Fire and EMS Frequencies

Quick answer: County-level fire dispatch that covers Alberta: Benton County Fire 154.0400 MHz, narrow FM, 146.2 PL. Trunked: Allied Radio Matrix for Emergency Response (ARMER), for example Benton County Fire talkgroup 24946 (hex 6172).

  • 3 conventional channels are analog FM, so any scanner can receive them. Enter the frequency and set the tone shown in the table.
  • Trunked radio systems that carry fire and EMS traffic here: Allied Radio Matrix for Emergency Response (ARMER): 1 talkgroup. A trunking scanner is required, and it must support the system type shown.
  • To follow a trunked system, program a control channel first. For Alberta, start with the Gilman - Simulcast site of Allied Radio Matrix for Emergency Response (ARMER), about 12 miles away. Its control channels: 852.4, 852.725 MHz.

Data updated .

Benton County channels that also cover Alberta

Fire Dispatch

Fire Dispatch frequencies for Benton County
AgencyDescriptionFrequency (MHz)ToneModeFCC
Benton County FireRice Fire Department154.0400
In 158.9400
146.2 PLFMNKNJH312
Benton County FireFoley Fire Department154.2500146.2 PLFMNWPJI508
Benton County FireSauk Rapids 911 – Paging155.1000
In 159.8250
146.2 PLFMNKR9809

Allied Radio Matrix for Emergency Response (ARMER)

Allied Radio Matrix for Emergency Response (ARMER) talkgroups
AgencyDescriptionTalkgroupHexMode
Benton County FireCounty Fire249466172D

Nearest trunked radio sites

Distances are measured from the center of Alberta.

Gilman - Simulcast · Allied Radio Matrix for Emergency Response (ARMER)
RFSS 4 · Site 49 (hex 31) · NAC 400 · about 12 mi away
Control 852.4, 852.725
Voice 851.425, 851.8, 851.9, 852.275, 852.875, 853.475, 853.525, 853.825
St. Cloud - Prison · Allied Radio Matrix for Emergency Response (ARMER)
RFSS 4 · Site 29 (hex 1D) · about 18 mi away
Control 856.2375, 857.2375
Voice 858.7375, 859.4375
St. Cloud Region Simulcast · Allied Radio Matrix for Emergency Response (ARMER)
RFSS 4 · Site 41 (hex 29) · NAC 405 · about 19 mi away
Control 856.9875, 857.4375, 857.9875, 859.0875
Voice 851.95, 852.3, 852.925, 853.9, 854.9875, 855.4625, 856.1375, 856.4375, 858.6625, 859.4625
What do these numbers mean?
Control channel
The frequency your scanner listens to first. It tells the scanner where each voice call is happening, so program it before anything else.
Voice
The other frequencies the site uses for calls. A trunking scanner follows them automatically once it has the control channel.
Site
One tower location of the system. Scanners show the number in decimal or hex, so both are listed.
RFSS (Radio Frequency Sub-System)
A group of sites run by the same controller. Large Project 25 systems can have several.
NAC (Network Access Code)
A hex code the site transmits. Your scanner can use it to ignore other systems on the same frequency.
Talkgroup
A virtual channel on a trunked system, such as one agency’s dispatch. Programming uses the decimal or hex number, depending on your scanner.

Common questions

What frequency does the fire department use in Alberta?

We do not have a fire dispatch channel listed specifically for Alberta. The county-level fire dispatch channels in the same county: Benton County Fire 154.0400 MHz, narrow FM, 146.2 PL.

Do fire departments and EMS use a trunked radio system in Alberta?

Yes. The county-level systems that cover Alberta are Fire and EMS talkgroups are listed for Allied Radio Matrix for Emergency Response (ARMER): 1 talkgroup. A trunking scanner is required.

What scanner do I need to listen to fire and EMS in Alberta?

The analog conventional channels can be heard on any scanner; a trunking scanner is needed for the trunked talkgroups.

What are the control channels for trunked radio in Alberta?

For Alberta, start with the Gilman - Simulcast site of Allied Radio Matrix for Emergency Response (ARMER). Its control channels are 852.4, 852.725 MHz. Program a control channel first; the scanner finds the voice channels from it.