Skip to content

Danville Fire and EMS Frequencies

We do not have frequencies listed specifically for Danville in Blue Earth County, Minnesota yet. Countywide channels for Blue Earth County that may also cover this area are shown below when we have them. The closest trunked radio site we have is Waldorf (Allied Radio Matrix for Emergency Response (ARMER)), about 9 miles away.

About Danville Fire and EMS Frequencies

Quick answer: County-level fire dispatch that covers Danville: Blue Earth County Fire 155.7600 MHz, narrow FM, CSQ. County-level ems dispatch that covers Danville: Blue Earth County EMS 155.2800 MHz, narrow FM, 156.7 PL. Trunked: Allied Radio Matrix for Emergency Response (ARMER), for example Blue Earth County Fire talkgroup 34408 (hex 8668).

  • 3 conventional channels are analog FM, so any scanner can receive them. Enter the frequency and set the tone shown in the table.
  • Trunked radio systems that carry fire and EMS traffic here: Allied Radio Matrix for Emergency Response (ARMER): 3 talkgroups. A trunking scanner is required, and it must support the system type shown.
  • To follow a trunked system, program a control channel first. For Danville, start with the Waldorf site of Allied Radio Matrix for Emergency Response (ARMER), about 9 miles away. Its control channels: 852.9125 MHz.

Data updated .

Blue Earth County channels that also cover Danville

Fire Dispatch

Fire Dispatch frequencies for Blue Earth County
AgencyDescriptionFrequency (MHz)ToneModeFCC
Blue Earth County FireCounty Paging – DES155.7600CSQFMNWQH303

EMS Dispatch

EMS Dispatch frequencies for Blue Earth County
AgencyDescriptionFrequency (MHz)ToneModeFCC
Blue Earth County EMSGold Cross Ambulance155.2800156.7 PLFMNKNHV592

Hospitals & Medical

Hospitals & Medical frequencies for Blue Earth County
AgencyDescriptionFrequency (MHz)ToneModeFCC
Blue Earth County HospitalImmanuel, St. Josephs155.3550156.7 PLFMNKQY593

Allied Radio Matrix for Emergency Response (ARMER)

Allied Radio Matrix for Emergency Response (ARMER) talkgroups
AgencyDescriptionTalkgroupHexMode
Blue Earth County FireBlue Earth Fire/EMS344088668D
Blue Earth County HospitalRegional Hospital Net344068666D
Blue Earth County HospitalMCHS Mankato ER – Patient Reports (Mayo Health)34442868aD

Nearest trunked radio sites

Distances are measured from the center of Danville.

Waldorf · Allied Radio Matrix for Emergency Response (ARMER)
RFSS 3 · Site 82 (hex 52) · about 9 mi away
Control 852.9125
Voice 851.3125, 851.475, 852.4125, 853.8875, 856.4875
Mapleton · Allied Radio Matrix for Emergency Response (ARMER)
RFSS 3 · Site 81 (hex 51) · about 11 mi away
Control 855.7125, 856.9375
Voice 851.175, 851.9625, 852.4625, 856.2125
Janesville · Allied Radio Matrix for Emergency Response (ARMER)
RFSS 3 · Site 31 (hex 1F) · about 15 mi away
Control 851.75
Voice 851.4125, 852.3875, 852.8875, 853.4125, 853.9125, 857.4375
What do these numbers mean?
Control channel
The frequency your scanner listens to first. It tells the scanner where each voice call is happening, so program it before anything else.
Voice
The other frequencies the site uses for calls. A trunking scanner follows them automatically once it has the control channel.
Site
One tower location of the system. Scanners show the number in decimal or hex, so both are listed.
RFSS (Radio Frequency Sub-System)
A group of sites run by the same controller. Large Project 25 systems can have several.
NAC (Network Access Code)
A hex code the site transmits. Your scanner can use it to ignore other systems on the same frequency.
Talkgroup
A virtual channel on a trunked system, such as one agency’s dispatch. Programming uses the decimal or hex number, depending on your scanner.

Common questions

What frequency does the fire department use in Danville?

We do not have a fire dispatch channel listed specifically for Danville. The county-level fire dispatch channels in the same county: Blue Earth County Fire 155.7600 MHz, narrow FM, CSQ.

What frequency does EMS or the ambulance service use in Danville?

We do not have a EMS dispatch channel listed specifically for Danville. The county-level EMS dispatch channels in the same county: Blue Earth County EMS 155.2800 MHz, narrow FM, 156.7 PL.

Do fire departments and EMS use a trunked radio system in Danville?

Yes. The county-level systems that cover Danville are Fire and EMS talkgroups are listed for Allied Radio Matrix for Emergency Response (ARMER): 3 talkgroups. A trunking scanner is required.

What scanner do I need to listen to fire and EMS in Danville?

The analog conventional channels can be heard on any scanner; a trunking scanner is needed for the trunked talkgroups.

What are the control channels for trunked radio in Danville?

For Danville, start with the Waldorf site of Allied Radio Matrix for Emergency Response (ARMER). Its control channels are 852.9125 MHz. Program a control channel first; the scanner finds the voice channels from it.