Skip to content

Elm Creek Fire and EMS Frequencies

We do not have frequencies listed specifically for Elm Creek in Martin County, Minnesota yet. Countywide channels for Martin County that may also cover this area are shown below when we have them. The closest trunked radio site we have is Sherburn (Allied Radio Matrix for Emergency Response (ARMER)), about 5 miles away.

About Elm Creek Fire and EMS Frequencies

Quick answer: County-level fire dispatch that covers Elm Creek: Martin County Fire 154.0400 MHz, narrow FM, CSQ. County-level ems dispatch that covers Elm Creek: Martin County EMS 155.1750 MHz, narrow FM, 100.0 PL. Trunked: Allied Radio Matrix for Emergency Response (ARMER), for example Martin County Hospital talkgroup 34814 (hex 87fe).

  • 4 conventional channels are analog FM, so any scanner can receive them. Enter the frequency and set the tone shown in the table.
  • Trunked radio systems that carry fire and EMS traffic here: Allied Radio Matrix for Emergency Response (ARMER): 1 talkgroup. A trunking scanner is required, and it must support the system type shown.
  • To follow a trunked system, program a control channel first. For Elm Creek, start with the Sherburn site of Allied Radio Matrix for Emergency Response (ARMER), about 5 miles away. Its control channels: 851.975, 852.975 MHz.

Data updated .

Martin County channels that also cover Elm Creek

Fire Dispatch

Fire Dispatch frequencies for Martin County
AgencyDescriptionFrequency (MHz)ToneModeFCC
Martin County FireCounty Fire154.0400
In 156.0000
CSQFMNWZX453
Martin County FireCounty Fire154.2500156.7 PLFMNWPJM772

EMS Dispatch

EMS Dispatch frequencies for Martin County
AgencyDescriptionFrequency (MHz)ToneModeFCC
Martin County EMSGold Cross Ambulance155.1750100.0 PLFMNWPQF670

Hospitals & Medical

Hospitals & Medical frequencies for Martin County
AgencyDescriptionFrequency (MHz)ToneModeFCC
Martin County HospitalFairmont Medical Center155.355097.4 PLFMNWQBT611

Allied Radio Matrix for Emergency Response (ARMER)

Allied Radio Matrix for Emergency Response (ARMER) talkgroups
AgencyDescriptionTalkgroupHexMode
Martin County HospitalMayo Clinic Health System Fairmont Hospital3481487feD

Nearest trunked radio sites

Distances are measured from the center of Elm Creek.

Sherburn · Allied Radio Matrix for Emergency Response (ARMER)
RFSS 3 · Site 76 (hex 4C) · about 5 mi away
Control 851.975, 852.975
Voice 851.3625, 852.375, 856.2625, 856.7625
Jackson · Allied Radio Matrix for Emergency Response (ARMER)
RFSS 2 · Site 78 (hex 4E) · about 12 mi away
Control 853.5625, 853.8125
Voice 851.075, 851.325, 851.8375
Fairmont · Allied Radio Matrix for Emergency Response (ARMER)
RFSS 3 · Site 75 (hex 4B) · about 14 mi away
Control 852.15, 857.9375
Voice 851.1125, 851.8, 857.4875, 858.4375
What do these numbers mean?
Control channel
The frequency your scanner listens to first. It tells the scanner where each voice call is happening, so program it before anything else.
Voice
The other frequencies the site uses for calls. A trunking scanner follows them automatically once it has the control channel.
Site
One tower location of the system. Scanners show the number in decimal or hex, so both are listed.
RFSS (Radio Frequency Sub-System)
A group of sites run by the same controller. Large Project 25 systems can have several.
NAC (Network Access Code)
A hex code the site transmits. Your scanner can use it to ignore other systems on the same frequency.
Talkgroup
A virtual channel on a trunked system, such as one agency’s dispatch. Programming uses the decimal or hex number, depending on your scanner.

Common questions

What frequency does the fire department use in Elm Creek?

We do not have a fire dispatch channel listed specifically for Elm Creek. The county-level fire dispatch channels in the same county: Martin County Fire 154.0400 MHz, narrow FM, CSQ.

What frequency does EMS or the ambulance service use in Elm Creek?

We do not have a EMS dispatch channel listed specifically for Elm Creek. The county-level EMS dispatch channels in the same county: Martin County EMS 155.1750 MHz, narrow FM, 100.0 PL.

Do fire departments and EMS use a trunked radio system in Elm Creek?

Yes. The county-level systems that cover Elm Creek are Fire and EMS talkgroups are listed for Allied Radio Matrix for Emergency Response (ARMER): 1 talkgroup. A trunking scanner is required.

What scanner do I need to listen to fire and EMS in Elm Creek?

The analog conventional channels can be heard on any scanner; a trunking scanner is needed for the trunked talkgroups.

What are the control channels for trunked radio in Elm Creek?

For Elm Creek, start with the Sherburn site of Allied Radio Matrix for Emergency Response (ARMER). Its control channels are 851.975, 852.975 MHz. Program a control channel first; the scanner finds the voice channels from it.