Skip to content

Peerless Fire and EMS Frequencies

We do not have frequencies listed specifically for Peerless in Daniels County, Montana yet. Countywide channels for Daniels County that may also cover this area are shown below when we have them. The closest trunked radio site we have is Scobey (Montana Public Safety Communications System), about 24 miles away.

About Peerless Fire and EMS Frequencies

Quick answer: County-level ems dispatch that covers Peerless: Daniels County EMS 158.2800 MHz, narrow FM, no tone.

  • 1 conventional channel is analog FM, so any scanner can receive it. Enter the frequency and set the tone shown in the table.

Data updated .

Daniels County channels that also cover Peerless

EMS Dispatch

EMS Dispatch frequencies for Daniels County
AgencyDescriptionFrequency (MHz)ToneModeFCC
Daniels County EMSDaniels County EMS – Dispatch158.2800FMNKDX848

Nearest trunked radio sites

Distances are measured from the center of Peerless.

Scobey · Montana Public Safety Communications System
RFSS 2 · Site 7 (hex 7) · about 24 mi away
Control 151.325, 161.925
Opheim · Montana Public Safety Communications System
RFSS 2 · Site 10 (hex A) · about 30 mi away
Control 151.43
Voice 151.34, 155.4225
Wolf Point 800 · Montana Public Safety Communications System
RFSS 2 · Site 18 (hex 12) · about 49 mi away
Control 853.6375
Voice 852.5375, 852.7875, 853.3875
What do these numbers mean?
Control channel
The frequency your scanner listens to first. It tells the scanner where each voice call is happening, so program it before anything else.
Voice
The other frequencies the site uses for calls. A trunking scanner follows them automatically once it has the control channel.
Site
One tower location of the system. Scanners show the number in decimal or hex, so both are listed.
RFSS (Radio Frequency Sub-System)
A group of sites run by the same controller. Large Project 25 systems can have several.
NAC (Network Access Code)
A hex code the site transmits. Your scanner can use it to ignore other systems on the same frequency.
Talkgroup
A virtual channel on a trunked system, such as one agency’s dispatch. Programming uses the decimal or hex number, depending on your scanner.

Common questions

What frequency does EMS or the ambulance service use in Peerless?

We do not have a EMS dispatch channel listed specifically for Peerless. The county-level EMS dispatch channels in the same county: Daniels County EMS 158.2800 MHz, narrow FM, no tone.

What scanner do I need to listen to fire and EMS in Peerless?

The analog conventional channels can be heard on any scanner.

What are the control channels for trunked radio in Peerless?

For Peerless, start with the Scobey site of Montana Public Safety Communications System. Its control channels are 151.325, 161.925 MHz. Program a control channel first; the scanner finds the voice channels from it.