Skip to content

Pee Pee Fire and EMS Frequencies

We do not have frequencies listed specifically for Pee Pee in Pike County, Ohio yet. Countywide channels for Pike County that may also cover this area are shown below when we have them. The closest trunked radio site we have is Scioto Trail (Waverly) (Ohio MARCS-IP: Multi-Agency Radio Communications), about 7 miles away.

About Pee Pee Fire and EMS Frequencies

Quick answer: County-level fire dispatch that covers Pee Pee: Pike County Fire Dispatch 154.8525 MHz, FM, 103.5 PL. County-level ems dispatch that covers Pee Pee: EMS Agencies 155.5575 MHz, FM, 85.4 PL. Trunked: Ohio MARCS-IP: Multi-Agency Radio Communications, for example Pike County Fire talkgroup 40004 (hex 9c44).

  • 6 conventional channels are analog FM, so any scanner can receive them. Enter the frequency and set the tone shown in the table.
  • Trunked radio systems that carry fire and EMS traffic here: Ohio MARCS-IP: Multi-Agency Radio Communications: 5 talkgroups. A trunking scanner is required, and it must support the system type shown.
  • To follow a trunked system, program a control channel first. For Pee Pee, start with the Scioto Trail (Waverly) site of Ohio MARCS-IP: Multi-Agency Radio Communications, about 7 miles away. Its control channels: 774.43125, 774.68125 MHz.

Data updated .

Pike County channels that also cover Pee Pee

Fire Dispatch

Fire Dispatch frequencies for Pike County
AgencyDescriptionFrequency (MHz)ToneModeFCC
Pike County Fire DispatchPike County Fire Dispatch154.8525
In 159.2625
103.5 PLFMWQBT852

Fire Ground / Tactical

Fire Ground / Tactical frequencies for Pike County
AgencyDescriptionFrequency (MHz)ToneModeFCC
Pike County Fire TacPike County Fire Tactical154.4300131.8 PLFMWNAP579

Fire Talk-around

Fire Talk-around frequencies for Pike County
AgencyDescriptionFrequency (MHz)ToneModeFCC
Pebble Twp Fire adminPebble Twp Fire admin154.2200FMWPVX387
Piketon-Seal Twp Fire adminPiketon-Seal Twp Fire admin154.3700FMKNCJ894

EMS Dispatch

EMS Dispatch frequencies for Pike County
AgencyDescriptionFrequency (MHz)ToneModeFCC
EMS AgenciesPike County EMS Dispatch/Operations155.5575
In 151.3775
85.4 PLFMWQBT852

EMS Tactical

EMS Tactical frequencies for Pike County
AgencyDescriptionFrequency (MHz)ToneModeFCC
EMS AgenciesPike County EMS tac155.205077.0 PLFMWPVN615

Ohio MARCS-IP: Multi-Agency Radio Communications

Ohio MARCS-IP: Multi-Agency Radio Communications talkgroups
AgencyDescriptionTalkgroupHexMode
Pike County FirePike County Fire – Dispatch400049c44D
Pike County FireFire Paging400369c64D
Pike County FirePike County Fire – Fire Ground400259c59D
Pike County EMSPike County EMS – Dispatch400199c53D
Pike County HospitalAdena Pike Hospital59923ea13D

Nearest trunked radio sites

Distances are measured from the center of Pee Pee.

Scioto Trail (Waverly) · Ohio MARCS-IP: Multi-Agency Radio Communications
RFSS 3 · Site 65 (hex 41) · NAC 340 · about 7 mi away
Control 774.43125, 774.68125
Voice 773.08125, 852.7125, 853.7875, 854.0875, 856.0875, 859.5375
Latham (Bainbridge) · Ohio MARCS-IP: Multi-Agency Radio Communications
RFSS 3 · Site 60 (hex 3C) · NAC 34B · about 11 mi away
Control 769.93125, 773.95625
Voice 769.68125
Richmond Dale · Ohio MARCS-IP: Multi-Agency Radio Communications
RFSS 3 · Site 64 (hex 40) · NAC 34F · about 12 mi away
Control 771.18125, 771.45625
Voice 770.05625, 851.8, 852.15, 852.375
What do these numbers mean?
Control channel
The frequency your scanner listens to first. It tells the scanner where each voice call is happening, so program it before anything else.
Voice
The other frequencies the site uses for calls. A trunking scanner follows them automatically once it has the control channel.
Site
One tower location of the system. Scanners show the number in decimal or hex, so both are listed.
RFSS (Radio Frequency Sub-System)
A group of sites run by the same controller. Large Project 25 systems can have several.
NAC (Network Access Code)
A hex code the site transmits. Your scanner can use it to ignore other systems on the same frequency.
Talkgroup
A virtual channel on a trunked system, such as one agency’s dispatch. Programming uses the decimal or hex number, depending on your scanner.

Common questions

What frequency does the fire department use in Pee Pee?

We do not have a fire dispatch channel listed specifically for Pee Pee. The county-level fire dispatch channels in the same county: Pike County Fire Dispatch 154.8525 MHz, FM, 103.5 PL.

What frequency does EMS or the ambulance service use in Pee Pee?

We do not have a EMS dispatch channel listed specifically for Pee Pee. The county-level EMS dispatch channels in the same county: EMS Agencies 155.5575 MHz, FM, 85.4 PL.

Do fire departments and EMS use a trunked radio system in Pee Pee?

Yes. The county-level systems that cover Pee Pee are Fire and EMS talkgroups are listed for Ohio MARCS-IP: Multi-Agency Radio Communications: 5 talkgroups. A trunking scanner is required.

What scanner do I need to listen to fire and EMS in Pee Pee?

The analog conventional channels can be heard on any scanner; a trunking scanner is needed for the trunked talkgroups.

What are the control channels for trunked radio in Pee Pee?

For Pee Pee, start with the Scioto Trail (Waverly) site of Ohio MARCS-IP: Multi-Agency Radio Communications. Its control channels are 774.43125, 774.68125 MHz. Program a control channel first; the scanner finds the voice channels from it.