Skip to content

Saw Creek Fire and EMS Frequencies

We do not have frequencies listed specifically for Saw Creek in Pike County, Pennsylvania yet. Countywide channels for Pike County that may also cover this area are shown below when we have them. The closest trunked radio site we have is Delaware Water Gap Bridge (New Jersey Interoperability Communications System (NJICS)), about 11 miles away.

Saw Creek also extends into Monroe County.

About Saw Creek Fire and EMS Frequencies

Quick answer: County-level fire dispatch that covers Saw Creek: Pike County Fire 155.2650 MHz, narrow FM, 173.8 PL.

  • 10 conventional channels are analog FM, so any scanner can receive them. Enter the frequency and set the tone shown in the table.

Data updated .

Pike County channels that also cover Saw Creek

Fire Dispatch

Fire Dispatch frequencies for Pike County
AgencyDescriptionFrequency (MHz)ToneModeFCC
Pike County FireFire/EMS Paging155.2650173.8 PLFMNWNQZ390

Fire Ground / Tactical

Fire Ground / Tactical frequencies for Pike County
AgencyDescriptionFrequency (MHz)ToneModeFCC
Pike County FireFireground 2 – East153.9500173.8 PLFMNWSEU923
Pike County FireFireground 3 – Landing Zone Operations154.1600173.8 PLFMNWQLL810
Pike County FireFireground 4 – West/Water Rescue Incidents154.1900173.8 PLFMNWQLL810
Pike County FireFireground 5 – Alternate/Fire Police154.2500173.8 PLFMNWQLL810
Pike County FirePike County Fire – Response154.4450
In 153.7700
173.8 PLFMNWNHQ590

Fire Talk-around

Fire Talk-around frequencies for Pike County
AgencyDescriptionFrequency (MHz)ToneModeFCC
Pike County FireFire Low Band B33.8600CSQFMKNCM850
Pike County FireFire Low Band A46.1800CSQFMKNCM850

EMS Tactical

EMS Tactical frequencies for Pike County
AgencyDescriptionFrequency (MHz)ToneModeFCC
Pike County EMSPike County EMS – Response151.2575
In 153.8600
69.3 PLFMNWQLN531

EMS Talk-around

EMS Talk-around frequencies for Pike County
AgencyDescriptionFrequency (MHz)ToneModeFCC
Pike County EMSPike County EMS – Alternate155.1600173.8 PLFMNWNNQ553

Nearest trunked radio sites

Distances are measured from the center of Saw Creek.

Delaware Water Gap Bridge · New Jersey Interoperability Communications System (NJICS)
RFSS 1 · Site 35 (hex 23) · NAC 39B · about 11 mi away
Control 773.55625, 773.84375, 774.06875
Voice 770.18125
Delaware Water Gap · New Jersey Interoperability Communications System (NJICS)
RFSS 1 · Site 19 (hex 13) · NAC 39C · about 12 mi away
Control 769.44375, 769.71875, 769.95625
Voice 773.09375, 773.81875, 774.04375
Dingmans Ferry (PIKE31) · PA-STARNet: Pennsylvania Statewide Radio Network
RFSS 1 · Site 105 (hex 69) · NAC 94C · about 13 mi away
Control 151.2875, 152.055
Voice 152.745
What do these numbers mean?
Control channel
The frequency your scanner listens to first. It tells the scanner where each voice call is happening, so program it before anything else.
Voice
The other frequencies the site uses for calls. A trunking scanner follows them automatically once it has the control channel.
Site
One tower location of the system. Scanners show the number in decimal or hex, so both are listed.
RFSS (Radio Frequency Sub-System)
A group of sites run by the same controller. Large Project 25 systems can have several.
NAC (Network Access Code)
A hex code the site transmits. Your scanner can use it to ignore other systems on the same frequency.
Talkgroup
A virtual channel on a trunked system, such as one agency’s dispatch. Programming uses the decimal or hex number, depending on your scanner.

Common questions

What frequency does the fire department use in Saw Creek?

We do not have a fire dispatch channel listed specifically for Saw Creek. The county-level fire dispatch channels in the same county: Pike County Fire 155.2650 MHz, narrow FM, 173.8 PL.

What scanner do I need to listen to fire and EMS in Saw Creek?

The analog conventional channels can be heard on any scanner.

What are the control channels for trunked radio in Saw Creek?

For Saw Creek, start with the Delaware Water Gap Bridge site of New Jersey Interoperability Communications System (NJICS). Its control channels are 773.55625, 773.84375, 774.06875 MHz. Program a control channel first; the scanner finds the voice channels from it.