Skip to content

Hillside Fire and EMS Frequencies

We do not have frequencies listed specifically for Hillside in Edmunds County, South Dakota yet. Countywide channels for Edmunds County that may also cover this area are shown below when we have them. The closest trunked radio site we have is Bowdle (South Dakota State Radio System), about 18 miles away.

About Hillside Fire and EMS Frequencies

Quick answer: County-level fire dispatch that covers Hillside: Edmunds County Fire 154.1300 MHz, narrow FM, CSQ. Trunked: South Dakota State Radio System, for example Edmunds County EMS talkgroup 1053 (hex 41d).

  • 4 conventional channels are analog FM, so any scanner can receive them. Enter the frequency and set the tone shown in the table.
  • Trunked radio systems that carry fire and EMS traffic here: South Dakota State Radio System: 1 talkgroup. A trunking scanner is required, and it must support the system type shown.
  • To follow a trunked system, program a control channel first. For Hillside, start with the Bowdle site of South Dakota State Radio System, about 18 miles away. Its control channels: 159.51, 159.87 MHz.

Data updated .

Edmunds County channels that also cover Hillside

Fire Dispatch

Fire Dispatch frequencies for Edmunds County
AgencyDescriptionFrequency (MHz)ToneModeFCC
Edmunds County FireRoscoe Fire154.1300CSQFMN—
Edmunds County FireRoscoe Fire154.1750CSQFMN—
Edmunds County FireIpswich Fire154.2500
In 150.8050
627 DPLFMNWQKX582
Edmunds County FireBowdle Fire154.9950
In 158.9400
162.2 PLFMNWQPL216

South Dakota State Radio System

South Dakota State Radio System talkgroups
AgencyDescriptionTalkgroupHexMode
Edmunds County EMSEdmunds County EMS – Dispatch105341dD

Nearest trunked radio sites

Distances are measured from the center of Hillside.

Bowdle · South Dakota State Radio System
RFSS 1 · Site 7 (hex 7) · NAC 477 · about 18 mi away
Control 159.51, 159.87
Voice 156.225, 159.045
Lowry · South Dakota State Radio System
RFSS 1 · Site 27 (hex 1B) · about 29 mi away
Control 159, 159.33, 159.81
Voice 160.155
Orient Hills · South Dakota State Radio System
RFSS 1 · Site 47 (hex 2F) · about 31 mi away
Control 158.49, 158.64
Voice 157.83, 157.95
What do these numbers mean?
Control channel
The frequency your scanner listens to first. It tells the scanner where each voice call is happening, so program it before anything else.
Voice
The other frequencies the site uses for calls. A trunking scanner follows them automatically once it has the control channel.
Site
One tower location of the system. Scanners show the number in decimal or hex, so both are listed.
RFSS (Radio Frequency Sub-System)
A group of sites run by the same controller. Large Project 25 systems can have several.
NAC (Network Access Code)
A hex code the site transmits. Your scanner can use it to ignore other systems on the same frequency.
Talkgroup
A virtual channel on a trunked system, such as one agency’s dispatch. Programming uses the decimal or hex number, depending on your scanner.

Common questions

What frequency does the fire department use in Hillside?

We do not have a fire dispatch channel listed specifically for Hillside. The county-level fire dispatch channels in the same county: Edmunds County Fire 154.1300 MHz, narrow FM, CSQ.

Do fire departments and EMS use a trunked radio system in Hillside?

Yes. The county-level systems that cover Hillside are Fire and EMS talkgroups are listed for South Dakota State Radio System: 1 talkgroup. A trunking scanner is required.

What scanner do I need to listen to fire and EMS in Hillside?

The analog conventional channels can be heard on any scanner; a trunking scanner is needed for the trunked talkgroups.

What are the control channels for trunked radio in Hillside?

For Hillside, start with the Bowdle site of South Dakota State Radio System. Its control channels are 159.51, 159.87 MHz. Program a control channel first; the scanner finds the voice channels from it.