Skip to content

Grandview II Fire and EMS Frequencies

We do not have frequencies listed specifically for Grandview II in Jackson County, South Dakota yet. Countywide channels for Jackson County that may also cover this area are shown below when we have them. The closest trunked radio site we have is Billsburg (South Dakota State Radio System), about 21 miles away.

About Grandview II Fire and EMS Frequencies

  • 1 conventional channel is analog FM, so any scanner can receive it. Enter the frequency and set the tone shown in the table.

Data updated .

Jackson County channels that also cover Grandview II

Fire Ground / Tactical

Fire Ground / Tactical frequencies for Jackson County
AgencyDescriptionFrequency (MHz)ToneModeFCC
Green Valley FireGreen Valley Fire151.0700
In 158.8500
100.0 PLFMNWQIR823

Nearest trunked radio sites

Distances are measured from the center of Grandview II.

Billsburg · South Dakota State Radio System
RFSS 1 · Site 6 (hex 6) · NAC 470 · about 21 mi away
Control 159.18, 159.96
Voice 159.36, 159.66
Wall · South Dakota State Radio System
RFSS 1 · Site 48 (hex 30) · NAC 470 · about 30 mi away
Control 155.535, 157.98, 158.52
Voice 157.83, 158.67
Long Valley · South Dakota State Radio System
RFSS 1 · Site 26 (hex 1A) · NAC 470 · about 38 mi away
Control 159.93, 160.2
Voice 156.195, 159.465
What do these numbers mean?
Control channel
The frequency your scanner listens to first. It tells the scanner where each voice call is happening, so program it before anything else.
Voice
The other frequencies the site uses for calls. A trunking scanner follows them automatically once it has the control channel.
Site
One tower location of the system. Scanners show the number in decimal or hex, so both are listed.
RFSS (Radio Frequency Sub-System)
A group of sites run by the same controller. Large Project 25 systems can have several.
NAC (Network Access Code)
A hex code the site transmits. Your scanner can use it to ignore other systems on the same frequency.
Talkgroup
A virtual channel on a trunked system, such as one agency’s dispatch. Programming uses the decimal or hex number, depending on your scanner.

Common questions

What scanner do I need to listen to fire and EMS in Grandview II?

The analog conventional channels can be heard on any scanner.

What are the control channels for trunked radio in Grandview II?

For Grandview II, start with the Billsburg site of South Dakota State Radio System. Its control channels are 159.18, 159.96 MHz. Program a control channel first; the scanner finds the voice channels from it.