Skip to content

Denver Fire and EMS Frequencies

We do not have frequencies listed specifically for Denver in Rock County, Minnesota yet. Countywide channels for Rock County that may also cover this area are shown below when we have them. The closest trunked radio site we have is Hardwick (Allied Radio Matrix for Emergency Response (ARMER)), about 5 miles away.

About Denver Fire and EMS Frequencies

Quick answer: County-level fire dispatch that covers Denver: Rock County Fire 154.2650 MHz, narrow FM, 141.3 PL. County-level ems dispatch that covers Denver: Rock County EMS 155.9550 MHz, narrow FM, 141.3 PL. Trunked: Allied Radio Matrix for Emergency Response (ARMER), for example Rock County Fire talkgroup 30902 (hex 78b6).

  • 4 conventional channels are analog FM, so any scanner can receive them. Enter the frequency and set the tone shown in the table.
  • Trunked radio systems that carry fire and EMS traffic here: Allied Radio Matrix for Emergency Response (ARMER): 4 talkgroups. A trunking scanner is required, and it must support the system type shown.
  • To follow a trunked system, program a control channel first. For Denver, start with the Hardwick site of Allied Radio Matrix for Emergency Response (ARMER), about 5 miles away. Its control channels: 853.5, 856.9625, 857.2625 MHz.

Data updated .

Rock County channels that also cover Denver

Fire Dispatch

Fire Dispatch frequencies for Rock County
AgencyDescriptionFrequency (MHz)ToneModeFCC
Rock County FireFire Paging154.2650
In 159.1350
141.3 PLFMNWQBD644

EMS Dispatch

EMS Dispatch frequencies for Rock County
AgencyDescriptionFrequency (MHz)ToneModeFCC
Rock County EMSEMS Paging & Ambulance Communications155.9550
In 153.9800
141.3 PLFMNWNSF990
Rock County EMSRock Co. Ambulance / EMS Paging156.1800
In 153.9200
141.3 PLFMNWNSF990

Hospitals & Medical

Hospitals & Medical frequencies for Rock County
AgencyDescriptionFrequency (MHz)ToneModeFCC
Rock County HospitalLuverne Community Hospital155.4000141.3 PLFMNKNHX328

Allied Radio Matrix for Emergency Response (ARMER)

Allied Radio Matrix for Emergency Response (ARMER) talkgroups
AgencyDescriptionTalkgroupHexMode
Rock County FireCounty Fire Dispatch3090278b6D
Rock County EMSRock County EMS – Dispatch3091978c7D
Rock County EMSRock County EMS – Dispatch3092078c8D
Rock County HospitalHospital – EMS3090778bbD

Nearest trunked radio sites

Distances are measured from the center of Denver.

Hardwick · Allied Radio Matrix for Emergency Response (ARMER)
RFSS 2 · Site 29 (hex 1D) · NAC 403 · about 5 mi away
Control 853.5, 856.9625, 857.2625
Voice 851.9125, 859.2125
Trosky · Allied Radio Matrix for Emergency Response (ARMER)
RFSS 2 · Site 37 (hex 25) · NAC 404 · about 9 mi away
Control 852.475, 856.4875
Voice 851.45, 856.2625, 857.4875
Chandler · Allied Radio Matrix for Emergency Response (ARMER)
RFSS 2 · Site 36 (hex 24) · NAC 400 · about 16 mi away
Control 851.425, 856.4375
Voice 852.875, 853.425, 859.2625
What do these numbers mean?
Control channel
The frequency your scanner listens to first. It tells the scanner where each voice call is happening, so program it before anything else.
Voice
The other frequencies the site uses for calls. A trunking scanner follows them automatically once it has the control channel.
Site
One tower location of the system. Scanners show the number in decimal or hex, so both are listed.
RFSS (Radio Frequency Sub-System)
A group of sites run by the same controller. Large Project 25 systems can have several.
NAC (Network Access Code)
A hex code the site transmits. Your scanner can use it to ignore other systems on the same frequency.
Talkgroup
A virtual channel on a trunked system, such as one agency’s dispatch. Programming uses the decimal or hex number, depending on your scanner.

Common questions

What frequency does the fire department use in Denver?

We do not have a fire dispatch channel listed specifically for Denver. The county-level fire dispatch channels in the same county: Rock County Fire 154.2650 MHz, narrow FM, 141.3 PL.

What frequency does EMS or the ambulance service use in Denver?

We do not have a EMS dispatch channel listed specifically for Denver. The county-level EMS dispatch channels in the same county: Rock County EMS 155.9550 MHz, narrow FM, 141.3 PL.

Do fire departments and EMS use a trunked radio system in Denver?

Yes. The county-level systems that cover Denver are Fire and EMS talkgroups are listed for Allied Radio Matrix for Emergency Response (ARMER): 4 talkgroups. A trunking scanner is required.

What scanner do I need to listen to fire and EMS in Denver?

The analog conventional channels can be heard on any scanner; a trunking scanner is needed for the trunked talkgroups.

What are the control channels for trunked radio in Denver?

For Denver, start with the Hardwick site of Allied Radio Matrix for Emergency Response (ARMER). Its control channels are 853.5, 856.9625, 857.2625 MHz. Program a control channel first; the scanner finds the voice channels from it.