Skip to content

Townsend Fire and EMS Frequencies

We do not have frequencies listed specifically for Townsend in Broadwater County, Montana yet. Countywide channels for Broadwater County that may also cover this area are shown below when we have them. The closest trunked radio site we have is Townsend (Montana Public Safety Communications System), about 19 miles away.

About Townsend Fire and EMS Frequencies

Quick answer: County-level fire dispatch that covers Townsend: Broadwater County Fire 154.2050 MHz, narrow FM, no tone. County-level ems dispatch that covers Townsend: Broadwater County EMS 155.7750 MHz, narrow FM, no tone. Trunked: Montana Public Safety Communications System, for example Broadwater County Fire talkgroup 253 (hex fd).

  • 4 conventional channels are analog FM, so any scanner can receive them. Enter the frequency and set the tone shown in the table.
  • Trunked radio systems that carry fire and EMS traffic here: Montana Public Safety Communications System: 1 talkgroup. A trunking scanner is required, and it must support the system type shown.
  • To follow a trunked system, program a control channel first. For Townsend, start with the Townsend site of Montana Public Safety Communications System, about 19 miles away. Its control channels: 142.4625, 149.225 MHz.

Data updated .

Broadwater County channels that also cover Townsend

Fire Dispatch

Fire Dispatch frequencies for Broadwater County
AgencyDescriptionFrequency (MHz)ToneModeFCC
Broadwater County FireBroadwater County Fire – Dispatch154.2050FMNWPLY297
Broadwater County FireFire Rural154.3100FMNWPLY294

Fire Ground / Tactical

Fire Ground / Tactical frequencies for Broadwater County
AgencyDescriptionFrequency (MHz)ToneModeFCC
Broadwater County FireSearch & Rescue153.8750FMNWQAX926

EMS Dispatch

EMS Dispatch frequencies for Broadwater County
AgencyDescriptionFrequency (MHz)ToneModeFCC
Broadwater County EMSBroadwater County EMS – Dispatch155.7750
In 158.9550
FMNWQDC483

Montana Public Safety Communications System

Montana Public Safety Communications System talkgroups
AgencyDescriptionTalkgroupHexMode
Broadwater County FireBroadwater County Fire – Dispatch253fdD

Nearest trunked radio sites

Distances are measured from the center of Townsend.

Townsend · Montana Public Safety Communications System
RFSS 1 · Site 9 (hex 9) · NAC 166 · about 19 mi away
Control 142.4625, 149.225
Nixon Ridge · Gallatin County / Bozeman
RFSS 1 · Site 4 (hex 4) · NAC 820 · about 26 mi away
Control 856.2625, 856.7625, 857.0875, 857.9875, 858.4625, 858.9375, 859.4625, 859.9375
Nixon Ridge · Montana Public Safety Communications System
RFSS 1 · Site 31 (hex 1F) · NAC 160 · about 26 mi away
Control 154.235, 154.74
Voice 154.875, 161.875
What do these numbers mean?
Control channel
The frequency your scanner listens to first. It tells the scanner where each voice call is happening, so program it before anything else.
Voice
The other frequencies the site uses for calls. A trunking scanner follows them automatically once it has the control channel.
Site
One tower location of the system. Scanners show the number in decimal or hex, so both are listed.
RFSS (Radio Frequency Sub-System)
A group of sites run by the same controller. Large Project 25 systems can have several.
NAC (Network Access Code)
A hex code the site transmits. Your scanner can use it to ignore other systems on the same frequency.
Talkgroup
A virtual channel on a trunked system, such as one agency’s dispatch. Programming uses the decimal or hex number, depending on your scanner.

Common questions

What frequency does the fire department use in Townsend?

We do not have a fire dispatch channel listed specifically for Townsend. The county-level fire dispatch channels in the same county: Broadwater County Fire 154.2050 MHz, narrow FM, no tone.

What frequency does EMS or the ambulance service use in Townsend?

We do not have a EMS dispatch channel listed specifically for Townsend. The county-level EMS dispatch channels in the same county: Broadwater County EMS 155.7750 MHz, narrow FM, no tone.

Do fire departments and EMS use a trunked radio system in Townsend?

Yes. The county-level systems that cover Townsend are Fire and EMS talkgroups are listed for Montana Public Safety Communications System: 1 talkgroup. A trunking scanner is required.

What scanner do I need to listen to fire and EMS in Townsend?

The analog conventional channels can be heard on any scanner; a trunking scanner is needed for the trunked talkgroups.

What are the control channels for trunked radio in Townsend?

For Townsend, start with the Townsend site of Montana Public Safety Communications System. Its control channels are 142.4625, 149.225 MHz. Program a control channel first; the scanner finds the voice channels from it.