About Rader Creek Fire and EMS Frequencies
Quick answer: County-level fire dispatch that covers Rader Creek: Jefferson County Fire 155.5950 MHz, narrow FM, no tone.
- 1 conventional channel is analog FM, so any scanner can receive it. Enter the frequency and set the tone shown in the table.
Data updated .
Jefferson County channels that also cover Rader Creek
Fire Dispatch
| Agency | Description | Frequency (MHz) | Tone | Mode | FCC |
|---|---|---|---|---|---|
| Jefferson County Fire | Jefferson County Fire – County Dispatch | 155.5950 In 153.8450 | FMN | WPWC864 |
Nearest trunked radio sites
Distances are measured from the center of Rader Creek.
What do these numbers mean?
- Control channel
- The frequency your scanner listens to first. It tells the scanner where each voice call is happening, so program it before anything else.
- Voice
- The other frequencies the site uses for calls. A trunking scanner follows them automatically once it has the control channel.
- Site
- One tower location of the system. Scanners show the number in decimal or hex, so both are listed.
- RFSS (Radio Frequency Sub-System)
- A group of sites run by the same controller. Large Project 25 systems can have several.
- NAC (Network Access Code)
- A hex code the site transmits. Your scanner can use it to ignore other systems on the same frequency.
- Talkgroup
- A virtual channel on a trunked system, such as one agency’s dispatch. Programming uses the decimal or hex number, depending on your scanner.
Common questions
What frequency does the fire department use in Rader Creek?
We do not have a fire dispatch channel listed specifically for Rader Creek. The county-level fire dispatch channels in the same county: Jefferson County Fire 155.5950 MHz, narrow FM, no tone.
What scanner do I need to listen to fire and EMS in Rader Creek?
The analog conventional channels can be heard on any scanner.
What are the control channels for trunked radio in Rader Creek?
For Rader Creek, start with the Red Mountain site of Montana Public Safety Communications System. Its control channels are 161.6, 161.825 MHz. Program a control channel first; the scanner finds the voice channels from it.