Skip to content

Ballantine Fire and EMS Frequencies

We do not have frequencies listed specifically for Ballantine in Yellowstone County, Montana yet. Countywide channels for Yellowstone County that may also cover this area are shown below when we have them. The closest trunked radio site we have is Pompey Pillar (Montana Public Safety Communications System), about 10 miles away.

About Ballantine Fire and EMS Frequencies

Quick answer: County-level fire dispatch that covers Ballantine: Yellowstone County Fire 155.8800 MHz, narrow FM, 114.8 PL. County-level ems dispatch that covers Ballantine: Yellowstone County EMS 155.2875 MHz, narrow FM, 127.3 PL. Trunked: Montana Public Safety Communications System, for example Yellowstone County Fire talkgroup 12452 (hex 30a4).

  • 2 conventional channels are analog FM, so any scanner can receive them. Enter the frequency and set the tone shown in the table.
  • Trunked radio systems that carry fire and EMS traffic here: Montana Public Safety Communications System: 2 talkgroups. A trunking scanner is required, and it must support the system type shown.
  • To follow a trunked system, program a control channel first. For Ballantine, start with the Pompey Pillar site of Montana Public Safety Communications System, about 10 miles away. Its control channels: 151.145, 151.2875 MHz.

Data updated .

Yellowstone County channels that also cover Ballantine

Fire Dispatch

Fire Dispatch frequencies for Yellowstone County
AgencyDescriptionFrequency (MHz)ToneModeFCC
Yellowstone County FireYellowstone County Fire – Dispatch /DES155.8800
In 158.8650
114.8 PLFMNWPZJ876

EMS Dispatch

EMS Dispatch frequencies for Yellowstone County
AgencyDescriptionFrequency (MHz)ToneModeFCC
Yellowstone County EMSAMR Dispatch / Careflight155.2875
In 150.7750
127.3 PLFMNKJW538

Montana Public Safety Communications System

Montana Public Safety Communications System talkgroups
AgencyDescriptionTalkgroupHexMode
Yellowstone County FireBillings Airport Fire1245230a4T
Yellowstone County EMSBillings Clinic Air Operations1249030caT

Nearest trunked radio sites

Distances are measured from the center of Ballantine.

Pompey Pillar · Montana Public Safety Communications System
RFSS 2 · Site 14 (hex E) · NAC 16F · about 10 mi away
Control 151.145, 151.2875
Voice 151.4375, 154.055
Billings Courthouse 800 · Montana Public Safety Communications System
RFSS 2 · Site 15 (hex F) · NAC 160 · about 21 mi away
Control 851.0375, 851.375
Voice 851.75, 852.7375, 853.1375, 853.4375
Billings South 800 · Montana Public Safety Communications System
RFSS 2 · Site 41 (hex 29) · NAC 161 · about 25 mi away
Control 855.2125, 855.7125, 856.4625
Voice 856.9625, 857.4625, 857.9625
What do these numbers mean?
Control channel
The frequency your scanner listens to first. It tells the scanner where each voice call is happening, so program it before anything else.
Voice
The other frequencies the site uses for calls. A trunking scanner follows them automatically once it has the control channel.
Site
One tower location of the system. Scanners show the number in decimal or hex, so both are listed.
RFSS (Radio Frequency Sub-System)
A group of sites run by the same controller. Large Project 25 systems can have several.
NAC (Network Access Code)
A hex code the site transmits. Your scanner can use it to ignore other systems on the same frequency.
Talkgroup
A virtual channel on a trunked system, such as one agency’s dispatch. Programming uses the decimal or hex number, depending on your scanner.

Common questions

What frequency does the fire department use in Ballantine?

We do not have a fire dispatch channel listed specifically for Ballantine. The county-level fire dispatch channels in the same county: Yellowstone County Fire 155.8800 MHz, narrow FM, 114.8 PL.

What frequency does EMS or the ambulance service use in Ballantine?

We do not have a EMS dispatch channel listed specifically for Ballantine. The county-level EMS dispatch channels in the same county: Yellowstone County EMS 155.2875 MHz, narrow FM, 127.3 PL.

Do fire departments and EMS use a trunked radio system in Ballantine?

Yes. The county-level systems that cover Ballantine are Fire and EMS talkgroups are listed for Montana Public Safety Communications System: 2 talkgroups. A trunking scanner is required.

What scanner do I need to listen to fire and EMS in Ballantine?

The analog conventional channels can be heard on any scanner; a trunking scanner is needed for the trunked talkgroups.

What are the control channels for trunked radio in Ballantine?

For Ballantine, start with the Pompey Pillar site of Montana Public Safety Communications System. Its control channels are 151.145, 151.2875 MHz. Program a control channel first; the scanner finds the voice channels from it.