Skip to content

How Fire and EMS Paging Works: Tone-Outs Explained

A tone-out is a short burst of audible tones that alerts one fire department or ambulance crew, followed by a voice message. Volunteer departments rely on them, so the channel is silent until a call. Most scanners play the tones as beeps and cannot pick out one department's tones.

The short version

A volunteer or paid-on-call fire department can't have someone sit by a radio all day. Instead, the dispatcher sends a short sequence of tones that sets off the department's pagers and radios, then reads out the call. This is called a tone-out or a page.

If you listen to a fire dispatch channel, you hear a burst of beeps or warbles, then the dispatcher's voice. The tones are meant for pagers and radios. The voice is the call.

What a tone-out sounds like

A typical page follows this pattern:

  1. Alert tones. A sequence of audible tones. In a common method, two tones are sent one after the other, and each department has its own pair. This is called two-tone sequential paging.
  2. The announcement. The dispatcher says which department is being paged, the type of call, and the location.
  3. Repeat. Many dispatchers repeat the page, because members may be driving or away from their pager.

Other methods exist. Some systems use touch-tone (DTMF) sequences or longer series of tones, and some alert pagers and phones with a data message instead of audio. The method differs between agencies and often between neighbouring counties.

What it means for a scanner

  • You hear the tones. A scanner plays them as beeps, and then you hear the dispatch message.
  • You hear every page on the channel. A countywide dispatch channel carries the tone-outs of every department in that county, and one scanner usually can't filter out the pages for a single department. The voice message tells you which department is being called.
  • Tones are not the same as PL tones. A PL or DPL tone is sub-audible and filters a channel. A paging tone is audible and alerts one department. See what the tone codes mean.
  • Decoding is a specialist job. Software that decodes paging tones, usually used with a software-defined radio, can show which department was paged. A basic scanner can't.

Where you will see it in listings

Descriptions on a fire dispatch listing often say how the channel is used, for example "Tone-Outs," "Paging," or "Paging Only." That tells you the channel is mostly quiet and busy only when a department is alerted. Some listings also mention siren activation sent by touch-tone from the dispatch centre.

Paging on trunked systems

On a trunked system the alert is often sent on a dispatch talkgroup instead of a conventional frequency. You still hear the alert tones and the voice message, and you hear them on the talkgroup you have programmed. Some departments on a trunked system also keep a conventional paging channel for their pagers. If your area has both, the conventional channel and the talkgroup may carry the same page.

EMS paging

Ambulance services and EMS agencies page crews in the same way, and some share the fire dispatch channel. In a county with a combined fire and EMS dispatch channel, you hear both kinds of call on it. In another county, EMS has its own channel, and it may be encrypted. See encrypted fire and EMS radio.

Frequently asked questions

Why does the channel go silent between calls?

Because the department's members are alerted by pager when a call comes in, they don't need to monitor the radio. Nothing is transmitted until there is a call. See why a fire channel is quiet.

Can my scanner tell me which department was paged?

Not usually. The dispatcher's voice message names the department. Software-based decoders can identify the tones.

Are the paging tones a secret code?

No. They are audible and can be heard on any scanner, but they are only meaningful to pagers and radios set to that department's tones.

Why do dispatchers repeat the page?

To make sure crews hear it. Members may be away from the pager, driving or in a noisy place.